The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate stations between P.C. (10 + 300m) and P.T. After laying out the curve, it was found out that the P.T. falls in a property lot and it should be moved in a way that the P.T. will be free from crossing the lot. As an ENGINEER, what would be your advice for relocation? Compute all the necessary elements of the old curve and new relocated curve. Property Lot P.C.O P.T.

The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate stations between P.C. (10 + 300m) and P.T. After laying out the curve, it was found out that the P.T. falls in a property lot and it should be moved in a way that the P.T. will be free from crossing the lot. As an ENGINEER, what would be your advice for relocation? Compute all the necessary elements of the old curve and new relocated curve. Property Lot P.C.O P.T.

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter14: Highway Surveys And Location

Section: Chapter Questions

Problem 17P: The following table shows the stations and ordinates for a mass diagram. The free-haul distance is...

See similar textbooks

Similar questions

A-1.10% grade meets a +0.60% grade at station 36+00 and elevation 800.00 ft. The +0.60 grade then joins a +2.40 grade at station 39+00. Part A Determine the elevation at the low point of the curve. Express your answer in feet to six significant figures. Elev = Submit Part B VAΣo↓ vec Request Answer Determine the station at the low point of the curve. Submit O 38+42.763 O 35+40.763 O 36+42.763 O 36+44.763 Request Answer ? ft
The data given for a vertical sagcurve on a roadway plan andprofile sheet are as follows: PVIstation @ 32+11.61, PVI elevation =54.18 ft, back tangent gradient g1 =- 4.00 percent, forward tangentgradient g2 = + 7.00 percent, andlength of curve L= 600ft. Determinethe curve elevations at half-station intervals along the curve,and compute the station andelevation of the lowest point. PLEASE PROVIDE COMPLETE AND COMPREHENSIVE SOLUTION AND FINAL ANSWER ASAP
The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate stations between P.C. (10+300m) and P.T. After laying out the curve, it was found out that the P.T. falls in a property lot and it should be moved in a way that the P.T. will be free from crossing the lot. As an ENGINEER, what would be your advice for relocation? Compute all the necessary elements of the old curve and new relocated curve. *check attached image for reference. ** please do not forget to include illustrations/sketches.
The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate stations between P.C. (10 + 300m) and P.T. After laying out the curve, it was found out that the P.T. falls in a property lot and it should be moved in a way that the P.T. will be free from crossing the lot. As an ENGINEER, what would be your advice for relocation? Compute all the necessary elements of the old curve and new relocated curve.
The angle between a 5-m full station of a certain curve is 10°. The curve has 7 intermediate stations between P.C. (10 + 300m) and P.T. After laying out the curve, it was found out that the P.T. falls in a property lot and it should be moved in a way that the P.T. will be free from crossing the lot. As an ENGINEER, what would be your advice for relocation? Compute all the necessary elements of the old curve and new relocated curve.Please do not reject this question and help me understand this complicated problem about curve relocation. It would be better if you will provide me with a detailed solution. Thank you!
Please answer number 4 and 5 only. Round off the answer to two decimal places
You are going to design a circular curve in a rural road segment where the design vehicleis a passenger car of operation speed is 90 km/h. The width of the lanes of the proposedroad is 3.5m. Based on a survey at the proposed site, it has been found that a multi-storiedbuilding is located towards the inside of the curve at 10 m from the centerline of thehighway. Considering perception reaction time as 2.5 s design the horizontal curve (Rdesign,edesign and fdesign) for that road segment. Record the radius and respective safe sight distancein the tabular format while selecting design radius (word table), plot them in Excel graphand find the Rdesignfor the safe sight distance. If there is no superelevation, what would bethe alternative arrangement?
Choose the correct answer in the choices bellow I'll rate!
Read the question carefully and give me right solution according to the question. Station 10+00.00 has an elevation of 110.00 and a grade of -3%. Station 20+00.00 has an elevation of 105.00 and a grade of +2%. What is the stationing at the two grade intersections? options A) 14+00, B) 15+00, C) 16+00, D) 17+00)
Two grades +2 % & +2 %, what is required to connect themSingle choice. choose one of the following none of the given circular curve crest vertical curve sag vertical curve
9
Assignment 3: Vertical Curve Design Question 2 The reduced level at the intersection of a rising gradient of P % and a falling gradient of Q % on a proposed road is XX.XX m. Given that K value is KK. The throught chainage of the intersection point is YYYY.YY m and proposed vertical curve is to have equal tangent. As a civil engineering you are required to prepare the following vertical curve design calculations: a) The through chainage of the points of the vertical curve if the minimum required length is to be used (Lv) and the vertical curve setting out data at 20 metres interval. b) The chainage and reduced level of the highest point on the curve. c) Through chainage at highest point was located exactly under a bridge, if the RL of soffit is SS.SS m, calculate the headroom based on proposed vertical curve design.