A homogenous bar with a cross sectional area of 500 mm2 is attached to rigid supports. It carries the axial loads P, 25 kN and P2 50 kN. Determine the stress (MPa) in segment BC P2 0.60 m 1.20 m 0.90 m

Q: ults in a differential element at the poin a a 0.5 m

A:

Q: The member shown has a rectangular cross section, determine the state of stress that loading…

A:

Q: Q1) Three bars AB, CD and ED are used to support ACE beam. The three bares have modulus of…

A: Draw the free body diagram. Equilibrium of vertical forces,…

Q: Problem (1) Three steel rods (E = 200 GPa) supports a 50 kN load P. Each of the rods AB and CD has a…

A:

Q: A prismatic bar has a cross-section of 25 mm by 50 mm and a length of 2000 mm. Under an axial load…

A: Width B=25 mm Depth D=50 mm Length L=2000 mm Load P=100 kN Elongation ∆L=2 mm Tensile stress & %…

Q: P A (0) B (2) (3) FIGURE P1.6/7 P1.7 WP Axial loads are applied with rigid bearing plates to the…

A:

Q: P A B 1m E 1m 2m The simply supported beam shown has a solid rectangular cross section having beam…

A: b = 130 mm h = 200 mm  P = 25 KN w = 30 KN/m

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Q: If the beam is subjected to an internal moment of M = 30 kN.m, determine the maximum bending stress…

A: Given : M = 20 kN-m This is a problem of Solid mechanics where we have to find the max. bending…

Q: Problem 7. [Concepts: Allowable stresses and factor of safety] Two aluminum rods AB and AC support a…

A:

Q: A steel pipe is subjected to the 16-kN load shown below. Its outside diameter is 140 mm and its…

A: A steel pipe is subjected to the 16-kN load shown below.Outer diameter = 140 mmThickness = 7 mmYield…

Material Properties

Construction in civil engineering demands high strength, durability, and longevity. These targets can be achieved by better design and analysis, along with the correct choice of materials. Different materials have different properties and hence, they respond and performs differently under the various condition of external loadings. It is therefore a critical task of an engineer to select the right material based on the property that the material is supposed to function in real-time. When speaking about the property, there are different categories of material properties like chemical property, physical property, mechanical property, electrical property, magnetic property, thermal property, etc. These material properties form the basis of material selection in various applications.