A helicopter is flying with a constant horizontal velocity of 180 km/h and is directly above point when a loose part begins to fall. The part lands 6.5 seconds later at Point B on an inclined surfac 180 km/h h A } 10° d • Determine the distance (d) between points A and B Determine the initial height (h) Your answer

Q: An airplane is used to drop water on brushfires is flying horizontally in a straight line at 150…

A: By using the kinematic equation the time and distance values for the given problem can be…

Q: A line of levels of 4 set-ups is run between 2 points using a 13-ft. level rod. The rod used has 0.1…

A: level setup 4 times13 ft level rid0.1 ft sawed off the bottomDifference in elevation 38.92ft

Q: 15. The slope distance from point F to G is 245 meters. The zenith angle from F to G is 105.25°.…

A: Given data:- The slope distance from F to G = 245 m The zenith angle from F to G =105.25°

Q: Why does Newton's method consistently outperform gradient descent?

A: Newton's method and gradient descent method are used in numerical optimization Required: To explain…

Q: Compute the volume using average end area for the following: A. A dam for a pond is 200ft long. B.…

A: Data given A dam for a pond is 200ft long. At Station 0+00.00 the top of the dam and existing grade…

Q: Problem 2 - The wind velocity at the top of Snowflex is given by the following u and v velocities,…

A: The component of velocity is givenTo determine the velocity and acceleration at point x = 2m and y =…

Q: s of the initial angle e (01 < 02)will cause the ball to pass through the center of the rim? Negled…

A:

Q: 14. Describe the process of setting up a level. 15. The slope distance from point F to G is 245…

A: Note: As per guidelines and student requirement,I have solved 1st question only.

Q: a. A 40-ft long (into the page) Tainter gate is shown below. It is being used by the U.S. Army Corps…

A:

Q: Q2: A stake is being pulled out of the ground by means of two ropes as shown. Knowing that a 5 308,…

A: Step 1: Step 2: Step 3: Step 4:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.