A generation station has the following daily load cycle: 20-24 16-20 12-16 10-12 6-10 0-6 Time (h) 40 X 55 45 50 40 Load (kW) Find the value of X, if the units generated between 3pm to 11pm is 290. Draw the load duration curve.

Q: 4.A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 Load…

A: In the generating system,  Daily load curve data are given Find the maximum demand Energy per day…

Q: power station has this daily load curve data (a) Draw the daily load curve. (b) Draw the load…

A: Answer shown below

Q: 200/0°V L In the circuit in the figure; • Ly load draws 15 kVA with lagging power factor 0.6. • The…

A:

Q: The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9…

A: pitch factor=cos(short pitch angle2). slot angle=180slot /pole.

Q: For the following circuit, determine the maximum power, PMax in Watts that can be transferred to the…

A:

Q: Determine the apparent power, active power and reactive power in a series circuit, when the supply…

A:

Q: A power station has the following daily load cycle: Time (Hours) 0-6 6-10 10 - 12 12 - 16 16– 20 20…

A:

Q: In matlab, To obtain voltage and current waveforms from transmission line which tool can be used O…

A:

Q: In class B chopper, which of the given statement is true The value of On time is always less than…

A: The formula for output voltage in step up chopper is, Vo = Vin/(1- delta)-----(1) Delta is the duty…

Q: An alternating current completes 5 cycles in 8 ms. What is its frequency?

A: Number of cycles = 5 Time = 8ms

Q: Copper losses in a generator vary with load

A:

Q: A generating station has the following daily load cycle :Time (Hours) 0-66-10 10-12 12–16 16-20…

A: In this question we will solve daily load curve .

Q: The power input measurement to a synchronous motor is done using the two- wattmeter method. Each of…

A: This question belongs to measurements and instrumentation . It is based on the concept of two…

Q: When a generator fails, its power output is lost, and the result is an imbalance between total load…

A:

Q: A tree-phase generator has a load 100 kw per phase at a power factor 80 percent,lagging what is the…

A: The active power consumed by a 3ϕ load is equal to the sum of active power consumed by each load.…

Q: A coal-fired combined cycle power plant serves a small city and has a load cycle shown below…

A: a) In Bar format  In Line format

Q: 10. Naghsh-Jahan Generation owns three generating units that have the following cost functions: Unit…

A: The generation cost is minimum when the incremental fuel cost of all the units are equal i.e.…

Q: The reactance of a generator is given as 0.25 pu based on the generator of 13 KV, 200 MVA. Determine…

A: Given, Reactance, Xg(old)= 0.25 pu Voltage, kV(old)= 13 kV Apparent power, MVA (old)= 200 MVA Base…

Q: The incremental cost characteristics of t generators delivering 200 MW are as follows: dF2 dP ah =…

A:

Q: A generation station has the following daily load cycle: 20-24 16-20 12-16 10-12 6-10 0-6…

A: we need to find out the value of X, and need to draw the load duration curve.

Q: In class B chopper, which of the given statement is true The value of On time is always less than…

A: Class B chopper is basically equivalent to step up chopper The circuit diagram of class B chopper…

Q: Plant A - 150kVA, 0.68pf lagging Plant B - 70kVA, 0.65pf lagging It is desired to correct the power…

A:

Q: A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 16-20…

A: This question belongs to power system . It is based on the concept of load curve . By making load…

Q: The incremental cost characteristics of two generators delivering 200 MW are as follows: dF₁ = 2.0 +…

A: Given the incremental cost characteristics of two generators, Generator 1 incremental cost…

Q: * Two generators, rated at 100 MW and 400 MW, are supplying power to a network. The system frequency…

A: we need to tell the value of droop R of the 100MW generator.

Q: A generating station has the following daily load cycle: Time (Hours)0-5|5-8 8 – 12 | 12 – 15 | 15 –…

A: i) From given data, It is clear from that maximum demand on the generating station is 80 MW and…

Q: The reactance of a generator is given as 0.55 pu based on the generator of 21 KV, 350 MVA. Determine…

A:

Q: A charge of 3500 VA to a with a power factov of 0,70 leading, connected of 50 Hz and Voltage of 23O…

A: The solution can be achieved as follows.

Q: A voltage of 200 253"8' is applied across to impedances in parallel. The values of impedances are…

A: Given data, Voltage V=200∠53.80 Impedances are given Z1=12+j1000 Ω, Z2=10-j20 Ω

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: We will find the pitch factor in each case as shown below.

Q: What are these load profiles? Explain their differences. Why is it important to know these load…

A: Load Profile: These load profiles are the graphs between the electrical peak load versus time. It…

Q: 63 G5 K

A: Definition: Short circuit MVA is equal to its MVA rating divided by its own per unit impedance or…

Q: An electrodynamometer type wattmeter is used to measure power in 1-o circuit. The connected load…

A: The solution is given below

Q: Q1) A system consists of two generators. Data of these generators as follow GI has 30 MW capacity…

A: Answer (A) From the data of G1 which is having 30 MW capacity  and the failure rate is 0.38day and…

Q: 800 KVAR capacitor is used to increase the power factor of a 1600 KVA power plant to 1. What is the…

A:

Q: A Load absorbs 10 kVA at a lagging power factor of 0.6. The complex power is: Select one: a. 2000+…

A: The correct solution is given below

Q: Efficiency Calcuate the load power out in MW. POUT = MW Calcuate the input power to the generator in…

A: In this question we need to find the following Load power  Power input to generator Efficiency of…

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: pitch factor can be calculated using the following relation Pitch factor = cos(alpha) / 2

Q: 1. Find the average power drawn by each charge. Total average power drawn by the load Find. 2. Find…

A: Node: The meeting point of more than two branches in a circuit is referred as a node. KCL: According…

Q: What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power…

A:

Q: Calculate the power factor of the er source. What is the average power supplied by the 102 4020°…

A:

Q: A three phase alternator has 48 slots and 4 pole. Find its distribution factor. A)0.9717 B)0.2298…

A: Given: Phase (m)=3 slots (s)=48 number of poles (P)=4

Q: Find power factor of given circuit 30/0° V rms -j22 ww

A: The cosine of the phase difference between voltage and current is known as power factor.  Power…

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.