A gaseous fuel containing methane and ethane is burned with excess air. The fuel enters the furnace at 25°C and 1 atm, and the air enters at 200°C and 1 atm. The stack gas leaves the furnace at 800°C and 1 atm and contains 5.32 mole% CO₂, 1.60% CO, 7.32% O₂, 12.24% H₂O, and the balance N₂. 1. Calculate the molar percentages of methane and ethane in the fuel gas and the percentage excess air fed to the reactor. 2. Calculate the heat (kJ) transferred from the reactor per cubic meter of fuel gas fed. 3. A proposal has been made to lower the feed rate of air to the furnace. State advantages and a drawback of doing so.

A gaseous fuel containing methane and ethane is burned with excess air. The fuel enters the furnace at 25°C and 1 atm, and the air enters at 200°C and 1 atm. The stack gas leaves the furnace at 800°C and 1 atm and contains 5.32 mole% CO₂, 1.60% CO, 7.32% O₂, 12.24% H₂O, and the balance N₂. 1. Calculate the molar percentages of methane and ethane in the fuel gas and the percentage excess air fed to the reactor. 2. Calculate the heat (kJ) transferred from the reactor per cubic meter of fuel gas fed. 3. A proposal has been made to lower the feed rate of air to the furnace. State advantages and a drawback of doing so.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

One hundred mole NH3/s and 200 mole O2/s at 25 degrees C are fed into a reactor in which the ammonia is completely consumed. The product gas emerges at 300 degreesC. Calculate the rate at which heat must be transferred to or from thereactor, assuming operation at approximately 1 atm. The standard heat ofreaction for the oxidation of ammonia is given below: NH3 (g) + 5O2 (g) → 4NO(g) + 6H2O(v); ΔHr^0= -904.7KJ(ΔHr^0-904.76KJ/s)
Using the ideal equation of state A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 52.0 cm wide and 62.4 cm high. The maximum safe pressure inside the vessel has been measured to be 6.60 MPa. For a certain reaction the vessel may contain up to 22.4 kg of chlorine pentafluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: c Explanation Check x10 80 X Ś F6 azinsight.adsrvr.org/track/clk?imp=fbec12b0-7f3d-4127-929d-a59782e61fbb&ag=r735012&sfe=1788cd47&sig=PCK7iCABpePPZo19wV_E9gKn0Pi6FOTr7R3rMUmfWw.&crid=2zvfx50b&cf=5773664&fq=0&t=2&td_szwww.chegg.com 8. 15 F7 W Danasia V DII dlo
0 ← = Account Balance Explanation 7 O STATES OF MATTER Using the ideal equation of state 76°F Mostly cloudy pressure:atm A Q Z ? X 2 A reaction between liquid reactants takes place at 31.0 °C in a sealed, evacuated vessel with a measured volume of 45.0 L. Measurements show that the reaction produced 11. g of dinitrogen difluoride gas. S https://www-awu.aleks.com/alekscgi/x/Isl.exe/1o_u-IgNslkr7j8P3jH-IBMBkpcnaFu0F7Uj... Calculate the pressure of dinitrogen difluoride gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Round your answer to 2 significant digits. Check X # Schedule Builder 3 k E D $ 4 R 0 10 LL JE X X > 1" do % 5 T OV C Give to Queensborough X Bb Announcements - 2022 F X A To S G 4- 6 B & H 7 U 144 * J 8 N M PE ( 9 K DDI B O ALEKS-Chisom Obidieg X (3 A J▬▬1/5 O > Ⓒ2022 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center | Accessibility 11:39 AM Ⓒ D 11/3/202232 W a P insert L + [ 1/5 ? = + A € prt sc 1 Chisom V…
A 0.2m3 rigid tank initially contains pure oxygen gas (02) at 20°C and 1000 kPa. The tank containing the oxygen is put on a scale to measure its mass. The initial mass is recorded as 110.4 kg. Nitrogen gas is injected isothermally into the tank until the scale reads 121.0 kg. The molar mass of oxygen is 32kg/kmol and the molar mass of nitrogen is 28 kg/kmol. Assuming that the gases behave ideally, answer the following questions: a) What is the mass of the empty tank? b) What is the composition of the final mixture on a mole basis? c) What is the final pressure of the tank? d) The critical temperature and pressure of oxygen are 154.6K and 49.8atm. Based on these properties, comment on the appropriateness of using the ideal gas law in part a)
Please don't provide handwriting solution
Hydrogen gas (H2) at 25°C, 1 atm enters an insulated reactor operating at steady state and reacts with 250% excess oxygen entering at 227°C, 1 atm. The products of combustion exit at 1 atm. Determine the temperature of the products, in K, if combustion is complete.
= O STATES OF MATTER Using the ideal equation of state A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 59.0 cm wide and 70.8 cm high. The maximum safe pressure inside the vessel has been measured to be 2.40 MPa. V For a certain reaction the vessel may contain up to 2.16 kg of carbon monoxide gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Be sure your answer has the correct number of significant digits. ctrl tab shift 1 temperature: °C Explanation esc K caps lock →1 fn PAVILION Type here to search f1 ? 1 Check A f2 8 2 Z W S HP Pavilion x360 hp Everywhere and every way f3 # 3 X E alt f4 $ D □ 4 x10 X O R C f5 % 밥 5 f6 T V 4- 6 G f7 ♫+ B & Y hp 7 H © 2022 McGraw Hill LLC. All Rights Reserved. Terms of Use | Priv a ? fg IAA * N 8 J fg M # K f10 f11 L > f12. 1/5 insert { 81°F…
Construct enthalpy cycles; use Hess's law and the enthalpy changes of formation below to calculate the enthalpy change for the reaction, CaCos(s) – ÇaQ(s) + CO2(g) AH, Cacoa(s) = -1207 kJmol-1 AH Cao(s) = -635 kJmol AH CO2(9) = -393 kJmol 1