A gas stream of ethane enters a mixer at 50 moles/min. A second gas stream that contains 40 mol% ethane and 60 mol% nitrogen enters at 30 moles/min. The product stream exits at 67 atm and 345 K. What is the volumetric flow rate in L/min? Assume steady-state conditions and no reactions. Do not assume ideal gas behavior.

Q: A reaction chamber is divided into two parts by a separator with a valve on it. The first section…

A: Chemical potential is the amount of energy released or absorbed during the chemical reaction or…

Q: 1.A battery of N stirred tank reactors is arranged to operate isothermally in series. Each reactor…

A: Given : Reaction : Pure solvent Reactor of the volume Concentration of A Concentration of A in the…

Q: Ethylene (C₂H4) enters an adiabatic combustion chamber at 25 °C, 1 atm and is burned with 40% excess…

A: a. Determine the temperature (T) of the products.b.Determine the entropy generation ().c.Determine…

Q: Consider the evaporation of 10% concentrated orange juice flowing at a rate of 2000kg/hr to 50%…

A:

Q: Nitrogen gas is compressed. Pressure rises from 100 kPa to 1500 kPa. Initial temperature of 25 deg…

A: Multi stage compressor requires less power compared to a single stage compressor for a given…

Q: 2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank…

A: Given Initial Pressure,P1=30×105Pa Operating temperature,T =200 K Volume of tank,V = 40m3 Length of…

Q: You are working on a plant where H2S is one of the feed stock to the reactor. The H2S needs to be…

A: Given: H2S is feed stock Preheated from 30oC to 300oC Pressure 40 bar

Q: Liquid ethanol (C2H5OH) at 25°C, 1 atm enters an insulated reactor operating at steady state and…

A: Given : Ethanol  is completely burned, so its conversion rate is 100%.The flue gas analysis…

Q: 290 K and the pressure is atmospherie. The residence time in the combustor is 0.1 s. As- suming the…

A:

Q: PLEASE I NEED HELP WITH THESE QUESTIONS. Please show work of the worksheet too. 1. Why do you use…

A: 1. Generally highest temperature is taken as it helps in estimate largest amount of heat tranferred.…

Q: 1. What is one potential use for substances that have a large amount of chemical potential energy?…

A: Chemical potential energy is the energy stored in the chemical bonds of a substance.  As with any…

Q: (A) Derive the equation for consecutive reaction.

A: Hi, according to our regulations we are allowed to answer one question per submission. Kindly…

Q: A chemical engineer is studying the two reactions shown in the table below. In each case, he fills a…

A:

Q: If the b. value of the distillation column feed equals 0.53, then the feed is O. Saturated liquid…

A:

Q: bicarbonate, and water. Assume that the density of every stream is 1.0 g/cm°. a. Determine the flow…

A: Given that  Stream 1 contains 300 mM heparin in water. Stream 2 contains 200 mM bicarbonate in…

Q: 5. Classify the following as endothermic or exothermic processes. a. boiling water b. running a race…

A: Introduction An exothermic process is a process or reaction that releases energy from the system to…

Q: 450 g of water at temperature of 22 °C is being heated until all of it is converted into steam.…

A: Weight of water = 450g = 0.45 kg Initial temperature = 22°c Final temperature = 100°c Specific heat…

Q: Please consider CO₂ that entered a process at the rate of 2.64 kg/min. The CO₂ entered at 274 °K and…

A: The initial mass flow rate of carbon dioxide is calculated. The mass balance is expressed in terms…

Q: 1. A three effect evaporator uses original steam at a saturation pressure of 174.4kPa gauge. The…

A: In case of a multi-effect evaporator, the pressure in each vessel will be lower than the pressure in…

Q: 5. You are required to design a distillation column in which an effluent mixture of methanol and…

A: A mixture of methanol and water is separated with the help of distillation column.

Q: At T = 300 K, the heat of mixing data for a binary liquid mixture of octanol and decane at…

A: Since the ratio of octane and decane is given 1 : 4 Hence in 1 mole of solution, moles of octane = 1…

Q: This is an open system with constant height and velocity. Put 100 kmol/s of H2 (H = 5141 kJ/kg) and…

A: Consider an open system with constant height and constant velocity in which following reaction is…

Q: A chemical reaction takes place in an adiabatic reactor, where no heat exchange occurs with the…

A: In an adiabatic reactor, there is no heat exchange with the surroundings, so the heat generated by…

Q: Example 2.4 Air is in a rigid tank of volume 1m' at initial pressure of 500kPa and temperature of…

A:

Q: Q4: A stream containing 500 kg/h methanol and 500 kg/h H2O is fed to a distillation column. There…

A: Given data: Flow rate of methanol=500kg/h flow rate of water=500kg/h Flow rate of bottom…

Q: A chemical engineer is studying the two reactions shown in the table below. In each case, she fills…

A: Given, Temperature, T= 100°C=373K N2g+O2g→2NO∆H=181 KJ=181×103 J∆S=530 J/K Calculate Gibbs free…

Q: 6. Term denoting the difference between the actual temperature and the saturation temperature at the…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: 47. The enthalpy change for the following reaction is known as: C,H.(g) + 30, (g) → 2CO:(g) +2H,0(g)…

A: C2H4(g)+3O3(g)→2CO2(g)+2H2O(g) To determine the type of enthalpy.

Q: Solve the following involving the First Law of Thermodynamics. Show your full solution.

A: Heat absorbed by the system = q+ (positive)  Heat evolved by the system = q− (negative) Work done on…

Q: If an anaerobic reactors operates at 1 atm and 35°C produced 20 m³/d of biogas with CH₁ of 50%,…

A:

Q: Chemical facilities use compressed air to operate pneumatic valves. The air (taken at ambient…

A: Given pressure of compressed air=90 psig dimensions of the storage cylinder= 2 ft diameter by 6 ft…

Q: Draw Process Diagram. 1. What are the balanced chemical reaction equations? 2. What is the pounds…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: A researcher will use a water bath to extract from Escherichia coli bacteria. He wants to use the…

A: Given Data : The amount of ice cube the researcher planned to use (m) = 135 g The initial…

Q: Based on BFD, identify whether the process is reactive or non-reactive. State all your assumptions…

A: Labeling the given flowsheet and commenting on the reactive or non-reactive process.

Q: Consider the combustion of propane: C3H8(g) + 502(g) → 3CO2(g) + 4H2O(I) ΔH = -2221 KJ Assume that…

A: Given for combustion of propane: C3H8(g) + 5O2(g) → 3CO2(g) + 4H2O(I)  ΔH = -2221 KJ

Q: Two streams are mixed in an adiabatic mixer, as shown in the figure. It is known that: • Stream 1 is…

A: m1×e1 +m2×e2-m3×e3+Q-w=0Assuming steady state. adiabatic mixer and no work . change in KE and PE is…

Q: Volumetric flow rates for an adsorber.Subquality natural gas contains an intolerable amount of N2…

A:

Q: Four liquids are described in the table below, Use the second column of the table to explain the…

A: a. Given, Mass of Sodium acetate=1.3 g Molar mass of Sodium acetate NaCH3CO2=82.034 g/mol Calculate…

Q: Using variables A, B, C as components, give an example of a rate law and a chemical reaction for a…

A: It is asked to form a nonelementary reaction along with the rate law using A , B and C