A flowmeter in a circuit uses US standard current transmission. The flowmeter can provide measurements from 0 gpm to 20 gpm. If the transmission current is 10 mA, what is the measured flow rate? 7.5 gpm     B. 12.5 gpm     C. 6 gpm      D. 10 gpm

Q: Estimate the differential pressure limit for a 0.5 mm thick, 25 mm diameter steel diaphragm pressure…

A:

Q: 2. Given the system below, what is the calibration range for the pressure transducer? Top Instrument…

A: Pmin is calculated using L=0 (min) Pmax is calculated using L=100 inch (max)

Q: You have an orifice meter that was calibrated for air at 70oF and I atm, You are using it to measure…

A: Given, calibrated conditions-                Tc = 70 * F = 294.26 K                 Pc = 1 atm…

Q: A 2.185 mm thick circular steel diaphragm (Em = 200 GPa, vp = 0.32, p= 4.49 kg / m³) within a…

A:

Q: Water is flowing from a garden hose (Fig. 5-39). A child places his thumb to cover most of the hose…

A:

Q: Calculate the velocity of a pressure wave in a 150 mm steel pipe carrying water. The pipe thickness…

A:

Q: Problem: Draw a pneumatic valve circuit to implement the function - T = A.B.C + A.C' + B.C'.

A: To find:Pneumatic valve circuit to implement the function.

Q: A cylinder is configured with a flow control valve to meter-out during extension. The cylinder is a…

A:

Q: An 8-in diameter piston is pushed inside a cylinder having an 8.005in diameter. The gap is filled…

A:

Q: In a given hydraulics circuit, the pump pressure is set to 80 bar (1160 psi), while the…

A: The pressure reducing valve is set at 30 bar:

Q: PLEASE ANSWER QUICKLY

A: Given: To find: Torsional stiffness Natural frequency

Q: Three arterioles of the same length are in parallel and connected to an artery. The flow rate in the…

A: the flow rate through arteries = Q = 300 ml/min flow rate through constricted arteries = Q3 = 50…

Q: Explain the use of an Arnold Meter, it's advantages and limitations as compared to a Hall Flow…

A: An Arnold meter is a device commonly utilized for the measurement of the flow rate of granular or…

Q: You want to figure out whether it is safe to touch the outsid surface of the pipe in question. Here…

A: GivenT1=70oCr=0.2mt=12mm=0.012mT2=30oCh=15W/m2Ck=54 W/moCL=1m

Q: In calibration of instrument the 0.055 percent of the calibration span what does it mean. If let say…

A: The calibration span is the total range of the instrument's observing range, which means the…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.