A: Flow is being measured by a Parshall flume with the following dimensions: 1830 mm. 13 1795 mm. C depth at the thsroat 500 mm. The flume is constructed to carry a 113 m3 min of wastewater. 1 Calculate the water deptlh in the converging section 1500 mm, D1935 mm, throat cidth 1200 mm, water

A: Flow is being measured by a Parshall flume with the following dimensions: 1830 mm. 13 1795 mm. C depth at the thsroat 500 mm. The flume is constructed to carry a 113 m3 min of wastewater. 1 Calculate the water deptlh in the converging section 1500 mm, D1935 mm, throat cidth 1200 mm, water

Name: Flow is being measured by a Parshall flume with the following dimensi
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Flow is being measured by a Parshall flume with the following dimensions:A 1830 mm. 1B= 1795 mm.C I500 mm, D 1935 mm, throat widthdepth at the thsroat 500 mmn. The flume is constructed to.carry a 113 m3/min of wastewater.1 Calculate the water deptih

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Find the hydraulic radius Wetted area=18.9 m2 Wetted perimeter=12.3 m
At the coastal side of Pampanga, a Tidal power generator was installed with a power capacity equal to 815 KW with a seawater density of 1,020 kg/cu.m. and vertical tidal surge range to 5.5 meters. What is the required area of the concrete Brage to be installed? 0.539 sq.m. B. 5.39 sq.m. (c) 53.9 sq.m. (D) 539.5 sq.m.
Solve this one
HYDRAULICS/FLUID MECHANICS. RATE WILL BE GIVEN. 3 DECIMAL PLACES
Solve this
Q1) What head H is needed in Fig. 3 to produce a discharge of 0.3 m/s? use minor loss coefficient of 0.5 for the entrance and 0.12 for diffusers. Figure 1. Lite beer 5.9.-1.00 0.05 pojse 30 m 210-mm diam Square edge Smooth pipe Fig. 1 60 m 305 mm diam B 450 mm diam 1634
Complete soln and correct units pls. Thanks
If a rectangular sharp-crested weir 1.25m long with no end contractions were to replace the triangular weir, what would be the required H in centimeters for a similar discharge? Use Francis formula.
1. An actual discharge from a reservoir takes place over a rectangular weir where the flow characteristic is Q= 1.77 BH 3/2 m³/s (a) Find the length of weir (b) The ratio of actual discharge to theoretical discharge * Required to discharge 9 m³/s, if head must not exceed 0.6m