A double-decker London bus might be in danger of rolling over in a highway accident, but at the low speeds of its urban environment, it’s plenty stable. The track width is 2.05 m. With no passengers, the height of the center of gravity is 1.45 m, rising to 1.73 m when the bus is loaded to capacity. What are the critical angles for both the unloaded and loaded bus?

A double-decker London bus might be in danger of rolling over in a highway accident, but at the low speeds of its urban environment, it’s plenty stable. The track width is 2.05 m. With no passengers, the height of the center of gravity is 1.45 m, rising to 1.73 m when the bus is loaded to capacity. What are the critical angles for both the unloaded and loaded bus?

Similar questions

To penetrate armor, a projectile’s point concentrates force in a small area, creating a stress large enough that the armor fails. A species of jellyfish launches a pointed needle that can penetrate the hard shell of a crustacean. The rapid deceleration on impact creates a 32 μN force on the tip, which has a very small 15 nm radius. What is the resulting stress? How does this compare to the ultimate stress of steel?
⦁ Imagine that you hold a 6.0kg lead ball in your hand with your arm bent. The ball is 0.35m from the elbow joint. The biceps muscle attaches to the forearm 0.050m from the elbow joint and exerts a force on the forearm that allows it to support the ball. The center of mass of the 12N forearm is 0.16m from the elbow joint. Estimate the magnitude of⦁ The force that the biceps muscle exerts on the forearm ⦁ The force that the upper arm exerts on the forearm at the elbow
Find the x and y-coordinates of the center of gravity of a 4.00-ft by 8.00-ft uniform sheet of plywood with the upper right quadrant removed as shown in the figure below. Hint: The mass of any segment of the plywood sheet is proportional to the area of that segment.
U.S. nickels have a mass of 5.00 g and are 1.95 mm thick. If you stack 3 nickels on a table, how far above the table is their center of gravity?
You can find the center of gravity of a long ruler by resting it horizontally on your two index fingers, and then slowly drawing your fingers together. First the ruler will slip on one finger, and then on the other, but eventually the fingers meet at the CG. Why does this work
We can model a pine tree in the forest as having a compact canopy at the top of a relatively bare trunk. Wind blowing on the top of the tree exerts a horizontal force, and thus a torque that can topple the tree if there is no opposing torque. Suppose a tree’s canopy presents an area of 9.0 m2 to the wind centered at a height of 7.0 m above the ground. (These are reasonable values for forest trees.) If the wind blows at 6.5 m/s: a. What is the magnitude of the drag force of the wind on the canopy? Assume a drag coefficient of 0.50.b. What torque does this force exert on the tree, measured about the point where the trunk meets the ground?
To get up on the roof, a person (mass 62.0 kg) places a 6.80 m aluminum ladder (mass 11.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The top of the ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2.00 m from the base, as measured along the ladder. The person is standing on the ladder 3.00 m from the base, as measured along the ladder. Find the normal reaction and friction forces (in N) on the ladder at its base. (Enter the magnitudes.) normal reaction force friction force
8.1
Pat builds a track for his model car out of wood. The track is 3 cm wide (along the z coordinate), 1 m high (along the y coordinate), and 2.7 m long (along the x coordinate starting from x = 0). The runway is cut such that it forms part of the left-hand side of a parabola, see figure below. Locate the horizontal position of the center of gravity of this track in m.
It's a beautiful sunny day and you decide to go fishing for small crappies. Instead a very large curious carp takes your bait and accelerates at a rate of 4.2 m/s^2 when it realizes that it is hooked. You only used fishing line that guarantees a max tensile strength of 25 pounds. What is the maximum weight (kg) of the carp you could catch without snapping the line?
A 10.0-kg monkey climbs auniform ladder with weight w =1.20 x 102 N and length L =3.00 mas shown in Figure P8.94. The ladderrests against the wall at an angleof θ = 60.0°. The upper and lowerends of the ladder rest on frictionlesssurfaces, with the lower endfastened to the wall by a horizontalrope that is frayed and that can support a maximum tension of only 80.0 N. (a) Draw aforce diagram for the ladder. (b) Find the normal forceexerted by the bottom of the ladder. (c) Find the tensionin the rope when the monkey is two-thirds of the way up theladder. (d) Find the maximum distance d that the monkeycan climb up the ladder before the rope breaks. (e) If thehorizontal surface were rough and the rope were removed,how would your analysis of the problem be changed andwhat other information would you need to answer parts (c)and (d)?
Part C - The z Component of the Center of Gravity of All the Components - 0.550 m, and z3 = 0.200 m, determine the z If the heights of the components are given as z1 = 2.00 m, 22 = component of the center of gravity of all the components. Express your answer to three significant figures and include the appropriate units. • View Available Hint(s) HA ? Value Units = Z Submit