A doctor prepared a drip of 60 mL per hour for a patient in ward B,  while the correct dose of  62 ml per hour must be administered to the patient. Determine (i) the absolute error of dosage given by the doctor                                      (ii) the relative error of the dosage

Q: A chemist prepares a solution of magnesium fluoride MgF2 by measuring out 0.0042μmol of magnesium…

A: Given that: Moles of Magnesium fluoride = 0.0042μmol Volume = 450 mL = 0.450L Concentration =?

Q: If 10.00 mL (measured using a volumetric pipette) of a solution is pipetted into a 50 mL beaker…

A: Given, Volume of the solution = 10.00 mL Weight of beaker = 43.015 g Weight of beaker+ weight of…

Q: TARTING AMOUNT X The Bay of Fundy in Nova Scotia, Canada is reported to have the largest tides in…

A: Given rate = 6.08 feet per hour  To calculate rate in meter per second.

Q: (a) The density of iron is 7.874g/cm^(3). Create two conversion factors from the density; (b) What…

A: Density is a physical property of a substance which is measured as the mass per unit volume. It is…

Q: A pediatrician writes a prescription for “diphenhydramine 7.5 mg PO Q 6 hours × 7 days” for a child…

A: (PO Q 6 hours * 7 days) in the prescription means the medicine has to be taken every 6 hours for 7…

Q: In preparing an infusion of the drug cetuximab, a pharmacist adds 15 mL of bacteriostatic water for…

A: Drug Trastuzumab 350mg. Here pharmacist adds 15 ml bacteriostatic water into it and resulting…

Q: You have a stock solution certified by a manufacturer to contain 245.0±0.2 ?g SO2−4/mL. You would…

A: GivenClass A tolerance -100mL volumetric flask= +/- 0.08mL Class B tolerance - 10mol volumetric…

Q: the diameter of a 16-gauge wire has a diameter of 0.05082 in. what length of wire in meter is found…

A: Diameter = 0.05082 inch. 1 inch = 2.5cm. 0.05082 inch = .05082 × 2.5 = 0.12705 cm.  Mass = 1.60lb =…

Q: After creating her standard curve for absorption versus the concentration (M) of FD&C Red 40 and…

A: The objective of this question is to find the percent by mass of FD&C Red 40 in the Kool-Aid…

Q: When 0.501 g of sucrose (table sugar, white microcrystalline solid) is dissolved in water (clear…

A: Quantitative  data are data which are obtained experimentally and helps In quantification of element…

Q: In the filtration step, the product is washed with "two 4 ml portions of ice-cold water". Explain…

A: Filtration is a type of physical separation method. In this method usually solids are separated from…

Q: If 10.00 mL (measured using a volumetric pipette) of a solution is pipetted into a 50 mL beaker…

A: The mass per unit volume of a substance is known as the density of the substance. The density of a…

Q: One way the U.S. Environmental Protection Agency (EPA) tests for chloride contaminants in water is…

A: Hi, as you have posted 2 questions and have not mentioned which one you want us to solve for you.…

Q: tank contains 60 kg of salt and 1000 L of water. A solution of a concentration 0.03 kg of salt per…

A: Given A tank contains 60 kg of salt and 1000 L of water. A solution of a concentration 0.03 kg of…

Q: Norepinephrine can be analyzed in human urine. A fixed amount of DHBA was added to each sample and…

A: The objective of the question is to understand the analytical function of adding DHBA in the…

Q: chemistry student weighs out 0.0266 g of phosphoric acid (H,PO), a triprotic acid, into a 250. mL…

A: Given- Mass of phosphoric acid= 0.0266g Volume of volume flask =250 mL  Concentration of NaOH…

Q: An antacid tablet weighing 0.938 g contained calcium carbonate as the active ingredient, in addition…

A: We know that, according to the law of conservation of mass in a chemical reaction, the mass of the…

Q: A tank contains 60 kg of salt and 2000 L of water. A solution of a concentration 0.015 kg of salt…

A: Use of differential equation.

Q: The hydrometer is a device for measuring the density of liquids. The bulb contains lead shot, and…

A:

Q: A chemist prepares a solution of mercury(II) iodide (HgI₂) by measuring out 0.0013 μmol of…

A: Given, Concentration of HgI2 solution = ? μmol/L moles of HgI2 = 0.0013 μmol Note: 1000 mL = 1 L…

Q: A prescription requires an 0.67 mL injection of a 1:100 solution of a drug. The pharmacy only…

A:

Q: (a) What is the concentration of hydrogen at the B face in kilograms of H per cubic meter? C'H(B) =…

A:

Q: A chemist prepares a solution of nickel(II) chloride (NICI,) by measuring out 1.2x 10 jumol of…

A: Moles of NiCl2=1.2×102 μmol Volume=250 mL

Q: In 1993 the Minnesota Department of Health set a health risk limit for BCME in groundwater of 2.00…

A:

Q: If the flux of molecules diffusing through an area of 1 µm² on a cell membrane is J₁, then the flux…

A: The particles or molecules travel from higher concentration to lower concentration is known as…

Q: After performing precipitation gra weighed the crucible with the wei of 23.2125 g, then 23.1136 g,…

A:

Q: 42.How many of the following should be included in a good hypothesis? (i) A prediction of the…

A: In a scientific research and development, proving of various scientific facts originate from the…

Q: How many of the following should be included in a good hypothesis? (1) A prediction of the results…

A: A hypothesis can be defined as a proposed explanation for a phenomenon that has been observed.

Q: When answering this problem, report the answer with the appropriate number of significant figures.…

A: Solution - According to this question - Given - Formula - no of mole = molarity x volume thus, no of…

Q: The color change of a chemical requires an overtitration of 0.04 mL. Calculate the percent relative…

A: Given, Experimental value = 50 mL + 0.04 mL = 50.04 mL True value = 50 mL Calculating the percent…

Q: A prescription requires an 4.82 mL injection of a 1:100 solution of a drug. The pharmacy only…

A:

Q: Suppose the absorbance of a 0.084 M solution of nickel(II) nitrate in water is measured to be 0.305…

A: The question pertains to the application of the Beer-Lambert Law, a fundamental principle in…

Q: The following particulate-level diagram best represents a(n).

A: We are given a particulate-level diagram as follows:

Q: A solution is made by mixing 5.40 g of toluene, CHg(1), with 954. mL of chloroform, CHCI3(1).…

A:

Q: The mass of a sample of solution is 6.12 ± 0.01 g and the volume is 6.5 ± 0.5 mL. a) What is the…

A: Given: Mass of a sample of solution = 6.12 ± 0.01 g Volume = 6.5 ± 0.5 mL To determine: a) What is…

Q: Perform the calculation and record the answer with the correct number of significant figures.…

A: In addition, substraction , multiplication or division, the answer should have the same number of…

Q: 210 mg glucose per 100 ml blood. Avg body contains 11 pints, how many grams glucose. 1 pt =…

A:

Q: A student pipetted 10 mL of a sample solution into a 250 mL volumetric flask and diluted it to the…

A: At first 10 mL of original solution is taken in 250 mL flask and the rest 240 mL of water is added…