A diesel engine has a compression ratio of 18 and a cut off ratio of 2.4. At the beginning of the compression process, the air in the cylinder is at 100kPa and 27°C. Assume the gas constant, R = 287.J/kgK, the specific heat at constant volume, Cy 718J/kgk, and the ratio of specific heats,= 1.4. Calculate; =

A diesel engine has a compression ratio of 18 and a cut off ratio of 2.4. At the beginning of the compression process, the air in the cylinder is at 100kPa and 27°C. Assume the gas constant, R = 287.J/kgK, the specific heat at constant volume, Cy 718J/kgk, and the ratio of specific heats,= 1.4. Calculate; =

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Needs Complete typed solution with 100 % accuracy.
Figure Q1 (a) and Figure Q1 (b) shows a C-shape block and rectangular hollow block respectively.
I need an answer quickly please.
|Read the problem statement and the solution provided. There may or may not be one or more mistakes in the solution. Go through the solution carefully and then do the following. 1. State if the solution is correct or incorrect 2. If the solution is incorrect, identify what is the mistake in the solution. Be specific and succinct. 3. If the solution is incorrect, provide the final solution with appropriate steps. You can make the corrections directly on a copy of this provided solution, but make sure you clearly explain the corrections. Problem: Consider fully-developed flow of water through a 24-cm diameter tube. The water comes in at 20°C and exits at 40°C. The surface temperature of the tube is uniform at 60°C. The water flow has a mass flow rate of 0.24 kg/s. What is the average convection coefficient of the water flow? Solution: We have T, = 60°C, Tmi = 20°C, Tmo = 40°C, So, the bulk-mean temperature is Tm = 30°C. The appropriate properties are: u = 7.98 × 10-4 kg/ms; k = 0.615…
construct a CNC program using G and M codes fo part drawing as shown below (take z=5 mm)
Select all the correct statements: a. Moment of force or toque is force multiplied by the perpendicular distance from the point of application of the force to the selected point or center. b. The perpendicular distance is also termed as moment arm. C. The axis of the moments and the planes of the forces are intersecting at the center of the moment. d. Graphically, the moment can also be defined as the area of the triangle formed by joining the center of moments with the ends of the forces. B
solve questions (7, 8 and 9)
q1