Q4 Draw Front, Top and side view of the drawing shown below. All dimensions in mm and scale 1:1.

Q: he air temperature is 5°C. Water cools from 100°C to 75°C in 5 minutes . How long will it take for…

A:

Q: HW) Can we create a hydraulic hand jack that can be used to lift heavy weights (say 1000 KN) by…

A:

Q: The air fan increases the pressure by-35 60 mmHg and the velocity by 10 m/s. The air density is 1.2…

A: Given data:

Q: what is the minimum energy to do a 1kw power

A: Given: Power, P = 1 kW = 1000 W Energy, E = ?

Q: Describe how the system works

A: A hydraulic system is a drive technique in which energy is transferred from an electric motor to…

Q: The coefficient of active pressure for an angle of internal friction of 30.4 degrees is?

A: When an amount of force is applied on an object to move it in a particular direction, that force can…

Q: Explain the differences between a rotodynamic pump and a positive displacement pump.

A:

Q: Write the monthly maintenance schedule or chart for compressor propeller

A:

Q: The car engine has a torque of 0.4 kNm at 2000 rpm (rev/min). What is the power (kW) at this time?

A: Given data: torque (T) = 0.4 kNm Speed (N) = 2000 rpm Need to determine the power.

Q: List any four advantages of the Horizontal Axis Wind Turbine.

A:

Q: List any four advantages of Vertical axis wind turbine.

A: In a vertical axis wind turbine (VAWT), the rotor arrangement is in the vertical direction. VAWT is…

Q: When recovering R134a into a recovery tank with the following specs. What will the tank weight when…

A: GIVEN: *R134a *WC is 27 lb (Water capacity) *TW is 20 lb (Tare weight)   TO FIND: *Tank weight…

Q: explain in a detailed manner how a bike start running when kick to the lever rod

A: Kickstarting is used to start an internal combustion engine, typically a motorcycle, by pushing…

Q: Counter and explain all the forces acting on a moving vehicle. Note: Do not include driving force.

A: During the vehicle's motion, a set of opposing forces was applied by the relative fluid medium. The…

Q: F+ 2) 15 H 94 140° FIND: F4 Magnutude and Gy (arectiva) 15°

A: Given, Forces are; 15 N, 9 N, 12 N, and F4

Q: If a car weighing 2400 lbs is able to go 1000 ft up a mountain incline whose angle of inclination is…

A: Given data: Weight of car = 2400 lbs                      Distance which car moves up the incline =…

Q: Define how to Energy transmission through rotating shafts is commonly encountered in practice.

A: When a member is subjected to torsional loads such as moments or couples about the centroidal axes…

Q: If a wind turbine is facing a wind velocity of 23.4 m/s, then it is Select one: a. Survival speed b.…

A: Solution: The maximum wind speed is also known as the maximum survival speed, is the speed above…

Q: A siphon consisting of a 3 cm diameter tube is used to drain water from a tank. The outlet end of…

A:

Q: Conclusion about Type of degree Thermometer

A:

Q: Write the name of the law relates with isobaric process

A: The law that relates to the isobaric process is Charles' law.

Q: 2- explain Diesel Engine Main Parts :

A:

Q: convert 35 psig in kPaa

A: Psig and kPa both are units of pressure. Psig = pound per square inch  kPa = kilo Pascal

Q: Venn Diagram of the difference between actual and theoretical discharge

A: To show the difference between actual discharge and theoretical discharge

Q: Is there vibration experienced by the helicopter? i. If yes, what caused it and how to reduce this…

A: Given data:Rotor blade resonant frequency - 6.7 HzFlutter speed - 28 m/sEngine output shaft speed -…

Q: Explain volumetric efficiency and cite any three factors that affect it

A: The volumetric efficiency and three factor affecting is given.

Q: List any four limitations of using conventional energy sources

A: There are two main sources of energy which can be written as below, 1. Source of conventional type…

Q: Make a research topic and question about underground cables

A: Given Underground cable To find Research topic and question

Q: What down the external sources of induced foot?

A: The external sources of induced foot are:-

Q: Select the main steps in the life cycle of of a pneumatic system.

A: Pneumatic System. A pneumatic system is a compressed air system that transmits energy and…

Q: What occurs during acceleration, which shifts the weight of the car from the front to the back

A: When car is accelerated then we feel some push towards back side. It is due to inertia.

Q: dium sized wind turbines with maximum power outputs of up ct one: a. 75000 Kilowatt b. 750000…

A:

Q: A pipe has a Re of 1000, what is the friction factor?

A:

Q: Where do people flee to when it becomes unsafe

A: Every day, individuals all around the globe make one of life's most painful decisions: to leave…

Q: Why do cylinders of compressed gases need to be kept upright and secured to a wall or bench top?

A: Gases that are compressed and held under pressure in cylinders are known as compressed gases. Liquid…

Q: al engineering

A:

Q: Give two problems that happen to engines that are used in the oil and gas industry and write a…

A: There are main two problems which are common and highly to be happen in engines that are used in oil…

Q: What is Extensometer?

A: The extensometer is the measuring device that measures the change in length of the object. It is…

Q: what is the process for finding the wind preesure from the windspeed of a fan? this is for fluid…

A: Pressure: It is the measure of the external applied force per unit area. Pressure = Force/Area

Q: A 50 Horsepower Diesel Engine with a brake thermal efficiency of 30% uses fuel oil with HV=18500…

A: Brake power of Diesel engine, B.P.=50 HPBrake thermal efficiency of the engine, ηbth=30 %Heating…

Q: How is the air exhausted at the back of the piston when the piston retracts?

A: By employing a single acting air cylinder in the application rather than a more traditional…

Q: With neat diagram, explain the wind turbine components such as Rotor, Drivetrain and Control System.

A: Block diagram for a wind turbine:

Q: The blower in our O&G lab is called centrifugal blower due to a. It moves with a forward curved…

A: Option b is correct.

Q: Fundamental equation that relates pressure to fluid's speed and height is known as O a. speed…

A: Let us discuss the fundamental properties of fluid.

Q: Low-cycle fatigue was the cause of the Comet failures. Estimate how many…

A: given; low-cycle fatigue was the cause of the comet failure?

Q: Why must the Cp value be estimated for oil when it is given in the problem statement.  i.e. why…

A: You want to know why the value of Cp is taken as 1.92 kJ/kg-K