a) Determine the total of land area needed to supply for 33.2×10' people, if the average energy usage per capita is 4,206 kWh. Consider that all our energy is obtained from solar by means of photovoltaic devices with an efficiency of 25% using horizontal panels. Assume that the solar panels facing the sun for 8 hours per day with the average solar irradiance is approximately of 160 W/m².

a) Determine the total of land area needed to supply for 33.2×10' people, if the average energy usage per capita is 4,206 kWh. Consider that all our energy is obtained from solar by means of photovoltaic devices with an efficiency of 25% using horizontal panels. Assume that the solar panels facing the sun for 8 hours per day with the average solar irradiance is approximately of 160 W/m².

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2.) An AC circuit is shown below. The AC power supply has Vrms = 120 V, frequency = 60 Hz. AC power supply ww 50 ohm 25HF A) What is the Vmax for the power supply? B) What is the Total resistance of the circuit? C) What is the Total capacitance of the circuit? D) What is the Total reactance of the circuit? E) What is the Total Impedance of the circuit? 1100⁰ 8 μF F) What is the maximum current (Imax) that will flow through this circuit? G) A fuse rated to 5.0 A is part of the circuit. Will it burn if this circuit is switched on? Provide an explanation for your answer.
q10
-A series circuit of two pure elements has the following applied voltages and resulting currents of 282.843 sin (314.159t + 30°) volts and 7.071 sin (314.159t - 23.13°) amperes respectively. What is the magnitude of the reactance of the circuit in ohms? -Two electrical loads are in operation: Load 1 consumes 10 kW at 0.8 pf lagging and Load 2 has an apparent power of 25 kVA at 0.6 pf lagging. What is the reactive power of load 1 in kVAR? -A series circuit of two pure elements has the following applied voltages and resulting currents of 282.843 sin (314.159t + 30°) volts and 7.071 sin (314.159t - 23.13°) amperes respectively. What is the magnitude of the voltage in polar form? -A impedance of Z = 15∠ 35° ohms is connected across a source with a voltage of 207.846 sin (157.08t) volts. For the circuit, what is the frequency in hz?
A PV module produces 263W maximum power at 1100 W/m?. Calculate the maximum power output at an irradiance level of 0.07 W/cm? Maximum power in Watts (W)
Determine the following for the circuit below
If the power input to the impeller is 500 Watts delivering a volume of 1000 m^3/h. What is the power input when the same impeller is delivering 500 m^3/h? Show complete solution.
8
Q1 In Ibra assume that the irradiance has a peak value of 900W/m2. For a 1 m2 solar panel, how much total energy is incident on the panel in a day if there are 10 hours of day light from sun rise to sun set? Repeat (a) if the area of the panel has been changed to be 5 m2.
I need the answer quickly
Find the average power absorbed by the resistor R R = 102 50/0°V + (rms) O a. 75 W O b. none of these O c. 150 W O d. 250 W O e. 125 W 2.50 www :2 Ideal www R 4
5 kN 2 H 20 nF Load a) the io b) average power absorbed by the load c) reactive power absorbed by the load where ig = 40 cos 5000t mA
A series circuit of two pure elements has the following applied voltages and resulting currents of 162.635 sin (314.159t + 36.87°) volts and 35.355 sin (314.159t -16.26°) amperes respectively. Determine the: a. the voltage in polar and rectangular forms; b. the current in polar and rectangular forms; c. the circuit impedance, resistance and reactance; d. the apparent power, S in waveform equation; and e. P, Q, S, and pf of the circuit.