a) Determine the total GMF surface area required to filter a volumetric flow rate of 10.0 MGD at a filtration rate of 4.0 gpm/ft2 . Divide the total surface area into an appropriate number of filter cells and determine the planar dimensions if square cells are used. Determine the percentage of the filtered water that will be used for backwashing under the following conditions,  Each filter cell is backwashed once every 24 hours • Backwashing rate of 20.0 gpm/ft2 • Each cell is backwashed for a duration of 10 minutes Also determine the filtration rate through the remaining filter cells when one cell is removed from service for backwashing.

Q: What is the solids loading on the filter assuming an influent TSS = 20 mg/L?

A: Step 1: Step 2: Step 3: Step 4:

Q: There is a sedimentation tank that is used to remove suspended solid particles (diameter of 100 um…

A: Given Data : ρp=2650 kg/m3 ρf=999.7 kg/m3 Dp=100×10-6 m μ=1.307×10-3 Ns/m2

Q: Name:.. 11. An activated sludge system has a single aeration basin with a volume of 300,000 gal and…

A:

Q: 5. Membrane filtration is increasingly being used in small water treatment facilities instead of…

A: To Find:the comparison between the backwash cycle in a dual media gravity and membrane filter.

Q: Compute the required volume of the aeration tank. If the SWD is to be 15 ft and the tank length to…

A:

Q: Disinfection, sedimentation, flocculation, coagulation, and filtration are processes for a surface…

A: Coagulation is defined as a water treatment process in which chemicals which are known as coagulants…

Q: A rapid sand filter system is designed for a city with population is 800,000 and the average water…

A:

Q: During filtration cycle, the valves A, B, C and E open/close as follo 1) A and B open and C and E…

A:

Q: A factory is discharging its wastewater into a slowly moving stream that has a mean velocity of 3…

A: Dissolved oxygen sag curve

Q: The following diagram illustrates the operation of a rapid sand filter. Washwater storage tank Water…

A: From the figure it can be seen that valve D is on the line taking water after filtration and also…

Q: A filter press with an effective filtering area between 350m^2 operates constantly maintaining a…

A: The objective of the question is to calculate the filtration velocity at a given time (t=120m) for a…

Q: In activated sludge system, SRT is governed by

A: Activated sludge system:

Q: A complete mix activated sludge secondary treatment plant is wasting from the return sludge line.…

A: Solution: Given Data: Mean cell solids residence time Qc=5 daysV=1000 L=1 m3MLVSS Xt=2000 mg/LWaste…

Q: Describe the main components and/or steps in designing dual-media filters for drinkingwater…

A: The number and size of filter beds are determined by the maximum day flow rate and the filtration…

Q: 3. A filter has been designed to have a run length of 48 hours while operating at a filtration rate…

A: A procedure, technology, or facility used to enhance the physical, chemical, or biological quality…

Q: Calculate Peak Wet Weather Flow given the following information about a wastewater treatment plant:…

A: Peak dry weather flow is given gyPDWF=Peak factor×ADWFADWF=Average Dry weather flowso,

Q: 4. A chlorinator setting is increased by 4 lbs/day. The chlorine residual before the increased…

A:

Q: - A 25 ml water sample is placed in a dish that wt. 50g, after evaporation and drying at 103°C, and…

A:

Q: Wastewater with DO concentration of 2 mg/L is discharged to a river. The temperature of the river is…

A:

Q: 1. A natural water with a flow of 4.0 MGD is to be treated with a commercial-grade alum dosage of 80…

A:

Q: Direction: An activated sludge system (sketched below) is operating at equilibrium with the…

A: An activated sludge system- Flow rate Q=500 m3/hr, BOD=150 mg/L, Effluent BOD=10 mg/L, MLSS=2000…

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.