(a) Derive an equation to predict the time tF for the drop to evaporate completely in a large volume of still air. Show all steps. (b) Calculate the time in seconds for complete evaporation.

Q: Consider a system of 6-in. ID vertical pipe with a falling film of water on the wall. Estimate he…

A: Given:  mass flow rate of water given i m*  =1570 lb/hr  diameter of pipe d = 6 in = 0.1524…

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.4 kg / s…

A: Given: T1 = 90 oC             T1 = 15 oC Required: Convection coefficient in the pipe hfood =?…

Q: 1. A gas bubble has a volume of 0.500 cm³ at the bottom of the lake where the pressure is 3.49 atm.…

A: GivenVolume of bubble at bottom of lake=0.500 cm3Pressure of bubble at bottom of lake=3.49…

Q: 1 mole of steam is pressurized at 5 bar in a horizontal cylinder equipped with a frictionless…

A: Note: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: 7. Joule-Thompson cooling of a gas occurs when the pressure of the gas drops as it goes through a…

A: If Z= f(x,y) is function of two variables say x and y. then total differential will be ;…

Q: A cylindrical open top vessel with 30 cm diameter contains 100 grams of water at 25 °C and 1 atm.…

A:

Q: A pipe (ID: 130 mm, OD: 165 mm, k=15 W/m²-K, Length: 2 meters) is insulated with several materials,…

A: Given Pipe have  Di=130mm D0=165mm K=15 W/(m2K) L=2m Inside fluid –Oil temperature T1=118℃ Outside…

Q: Manometers A cylindrical column is partially filled with three liquids: water, mercury, and…

A:

Q: the following Question: problems: Use the psychrometric charts to answer I. The wet bulb and dry…

A:

Q: The glycerine with a mass flow rate of 700kg/h passes through a pipe with an inner diameter of 30…

A: glycerine mass flow rate =700kg/h  pipe inner diameter Di=30 mm length of heated section L=2.5m…

Q: An incompressible Newtonian liquid is made to flow in the annular region between a cylindrical rod…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: Reconsider Prob. 14–140. Using EES (or other) software, plot the mass transfer coefficient as a…

A: A wet circular duct is to be dried through dry air. Temperature of air = 15 0C Pressure = 1 atm…

Q: Problem 2. Water is flowing through a circular pipe of radius R=2.5cm. The velocity profile of the…

A: Given, The velocity profile, v = v01-rR1/7 Where, v0 = 3 m/s The radius of circular pipe, R = 2.5 cm…

Q: A sample unknown gas expands in volume from 1.4 L to 3.6 L at constant temperature. Determine the…

A: Given V1=1.4L V2=3.6L P=0.3atm Find Work, W(J)

Q: VII. ASSIGNMENT Consider the following problem. 1. A lead bullet with a mass of 7.8 g and a velocity…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: a) The temperature of the steam, b) The quality c) The volume percentage of the saturated steam

A: Consider the steam boiler has a saturated water mixture. Provided Data: V=1.5 m3m=750 kgP=1 MPa

Q: Air at 22˚C and at atmospheric pressure flows over a flat plate at a velocity of 1.65 m/s. If the…

A: GivenTα=22°C v=1.65 ms Ts=110°C length=2.179m b=1m ρ=1.058 kgm3 cp=1.005 KJKg °C k=0.02897 wm °C…

Q: Problem 3. A liquid is flowing through an 8cm diameter pipe. It is being heated by a hot fluid…

A: here we have velocity data , so we have to find a perfectly fit curve for the given data points.…

Q: Figure 1 describes a sequence of activities that takes place during solvent extraction. Explain…

A: In figure A A= mass of carrier liquid in feed for stage 1 from which solute is to be extracted in…

Q: This question is designed to help you understand the constant mass expansion (CME) experiment for an…

A: Thank you,Please rate my response.

Q: A mixture of air and water at a temperature of 25°C flows up through a vertical tube with a length…

A:

Q: (2.32) A feed stream to a chemical reactor consists of 0.2 kg/s of ammonia vapor at 300 K. Prior to…

A:

Q: A gas from a dry gas reservoir has a specific gravity of 0.735 at reservoir temperature of 200…

A: Given = SG = 0.735Tr = 200F = 659.67 oRPr = 1800 PsiaTo find = Z and Bg

Q: Radioactive wastes (krw = 20 W/m•K) are stored in a spherical stainless steel container (kss 15…

A: Given data: Thermal conductivity of thermal wastes (krw) = 20 W/m∙K Thermal conductivity of…

Q: QUESTION 3 Figure 3 shows the initial state of a system. Container A of 1 m3 contains Air at 300 K…

A: Given : Initial volume Initial pressure Temperature Gas constant Specific heat at constant volume

Q: Carbon dioxide at 300 K and 1 atm conditions will be pumped through a channel with a square section…

A:

Q: The equivalent pressure of 14.7 psia in units of psig is: Answer:

A:

Q: Calculate the total energy, in kilojoules, that is needed to turn a 12 g block of ice at 0 degrees C…

A: Mass of Ice block m = 12g  Initial temperature = 0°c  Final temperature = 135°c  Data taken from…

Q: Liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.35 kg / s…

A: Given that, The temperature of liquid food Ti = 90oC = 363.15 K Mass flow rate m˙ = 0.35 Kgs…

Q: liquid water at 294.26 K. flows in a straight horizontal pipe in which there is no exchange of…

A: Enthalpy change of the water for the given flow is to be determined.

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.3 kg / s…

A: Given DataMass flow rate of food  m=0.3 kg/sSpecific heat of food  Cp=4 KJ/kg.KThermal conductivity…

Q: a) Calculate the convective coefficient h for water inside the pipe. b) Calculate the overall…

A:

Q: Calculate the melting point of ice under a pressure of 10 MPa in Kelvin. Assume that the density of…

A:

Q: the cor

A: