A copper wire of length 3m and 1mm diameter is subjected to a tension of 5N. Calculate the elongation produced, if the young’s modulus of copper is 120GPa. a) 15m b) 1800m c) 0.125 ×10-3 m d) 15.9mm

Q: An 80 cm long bar contracts axially by 0.2 mm when a compressive load is applied to it. Determine…

A: Given: Length of bar= 80 cm = 0.80 m            Contraction in bar = 0.2 mm = 0.0002 m  To find:…

Q: 1. For a string that has a change in length (AL) given by 0.40 cm and an applied force of 800 N. If…

A: The change in length,∆L=0.40 cm = 0.40×10-2 mThe applied force, F=800 N Young's modulus, Y=20×1010…

Q: 3.00m long steel wire is fixed in a ceiling and a mass of 12.3kg is hanging from the wire. The wire…

A:

Q: 6. Consider a long wire of cross-sectional area A, initial length Lo, and extension of the wire AL.…

A: According to question we need to define young modulus.

Q: Stress (MPa) 800 Breaking point 600 Elastic limit 400 200 Eļastic behavior Strain 0.002 0.004 0.006…

A:

Q: large plate nade 345 MPa determine the O 0.0182 mm O 9.079 mm

A: Given The Plane Strain fracture toughness = 82.4MPam The Plate is exposed to a tensile stress of 345…

Q: 3 x 10, then find out the percentage change in its volume. is applied on it due to which it suffers…

A: Poisson's ratio is defined as the ratio between transverse strain and longitudinal strain.

Q: An ACL has an unloaded length of 3.8 cm and is subject to a tension stress that results in a 5%…

A: Given,

Q: 4. A silicon nitride reinforced copper composite contains 30% by volume of fibres. The properties of…

A:

Q: The elastic limit of brass is 379 MPa. What should be the minimum diameter of a brass rod if it is…

A:

Q: 1.) A round hollow steel shaft has an inside diameter of 20mm, and transmits 10 kW at 1740 rpm.…

A:

Q: 63 : A steel wire of diameter 1 x 10³ m is stretched by a force of 20 N. Calculate the strain energy…

A: Description of the question : In this following question we have to find the strain energy per unit…

Q: A copper wire of length 4.4 m, cross sectional area 2.8 x 10 m and Young's modulus 11 x 10-0 N/m2…

A:

Q: A 439 kg load is hung on a wire of length 9 m, cross-sectional area 0.200 x 10* m, and Young's…

A:

Q: 52 : A volume of 10- 3 m³ of water is subjected to a pressure 10 atmosphere. The change in the…

A: In this question we have to find the bulk modulus of the water. as we know the bulk modulus is…

Q: A rectangular bar of length L tapes uniformly from a diamaeter D at one end to a smaller diameter d…

A: Hooke's Law:In the elastic region, the material behaves according to Hooke's Law, meaning that the…

Q: QUESTION 6

A: Answer            C. Elastic limit

Q: 4. A composite of polycrystalline spinel (Young's modulus = 277 GPa) and aligned and continuous…

A: A composite is formed with a polycrystalline spinel and fibre in order to increase the capacity of…

Q: 200 stress 150 (MPa) t00 50 0-2 strain From the tensile stress-strain behavior tor the brass…

A:

Q: A composite of steel anc composite is found to be Material Steel Aluminium

A: Given: The Young's modulus of the composite is found to be 126.35 GPa=1.2635×1011 Nm2 The Composite…

Q: Determine the pressure required reduce the given volume of water by 1%. Bulk N / modulus of water 2…

A: To find-Pressure (dP)=?Given data-dV=1100VK=2×103 N/m2

Q: load (KN) Elongation (mm) AL D O 0.5 0.3 3-8 7-9 12.9 14.3 15-9 16-9 17-8 19.1 21-2 24-2 26-9 30…

A: Given Height Lo   = 6.5 mm Diameter d = 5.9 mm Area Ao      = π4 d2 = π4 5.92 = 27.325 mm2 From the…

Q: It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.20…

A:

Q: 1. Calculate the elongation of the cable due to load, if a steel cable of 4cm diameter is used to…

A:

Q: The equation used in this experiment relating stress o and strain e, will apply: O a. only for…

A:

Q: A wire of length 2m and cross sectional area 104 m² is stretched by a load 102kg the steel wire is…

A: We have to compute here,(a) Longitudinal stress(b) Longitudinal strain(c) Young's modulusWe have…

Q: The wire has a diameter of 0.84 mm and a natural length of 3.5 m. Use the graph to determine: a the…

A:

Q: 2. A 4.0 m long copper wire of cross-sectional area 2 2 cm is stretched by a force of 4.8 x 10° N.…

A:

Q: 2. The puncher is to drive a 25 mm diameter hole to a steel plate. If the allowable axial stress of…

A: Given, diameter= 25 mm Axial stress = 101.85 MPa The maximum shear stress= 50 mm

Q: D = 0.4 mm diameter and I = 1 m long molybdenum wire is lengthened by force F = 41 N for Al = 1 mm.…

A: Dear student The Young modulus is defined as : Y = Stress / Strain Here, Stress = Force / Area…

Q: 1. A wire of radius 0.8 mm and length of 2.5m is stretched by a force of 49N. calculate the stress,…

A:

Q: 2- Determine the natural frequency of vibration of the SDOF system. Assume rigid girder. 4k/Et Steel…

A:

Q: A large 75-kg lighting fixture can be hung from wires of identical size and shape made of aluminum,…

A: The mass is 75 kg.The Young's modulus of aluminum is 0.70x1011 Pa.The Young's modulus of brass is…

Q: small body having mass 1kg is rotating in a circle of radius 10cm. It is connected to the centre…

A: Given: A small body having mass 1kg is rotating in a circle of radius 10cm. It is connected to the…

Q: 10. Young's Modulus for steel is 2.1 x 1011 Pa. A steel cable will break if it is subjected to a…

A: Young's modulus (Y) = 2.1×1011 PaArea (A) = 1.5×10-5 m2Length (L) = 18 m maximum stress = 3000 MPa

Q: A wire stretches from 2000 mm to 2005 mm when a 500-N box hangs from one end of it. The wire has a…

A: Original length of wire (L) = 2000 mm = 2 m New length of wire (L') = 2005 mm= 2.005 m Force (F) =…