A copper bar is welded end to end to a bar of an unknown metal.The two bars have the same lengths and cross-sectional areas. The free endof the copper bar is maintained at a temperature TH that can be varied. Thefree end of the unknown metal is kept at 0.0°C. To measure the thermalconductivity of the unknown metal, you measure the temperature T at thejunction between the two bars for several values of TH. You plot your dataas T versus TH, both in kelvins, and find that your data are well fit by astraight line that has slope 0.710. What do your measurements give for thevalue of the thermal conductivity of the unknown metal?

Q: Question 5: Z=62 a. An iron sphere of mass (Z + 300)g is kept in a container having boiling water…

A: Answer (a) Given data: m=300+62=362 gT1=100°CT2=25.5°CC=452 J/kg Need to determine the heat absorbed…

Q: 2. The 40mm diameter steel rod AB shown in Figure 2 is resting on frictionless rollers between two…

A:

Q: If the radius of wire stretched by a lo= doubled then its Young's modulus (a) will be doubled (b)…

A: we know that Young modulus is equal to the ratio of stress and  the strainY=σεY=FA∆ll

Q: A wall without heat generation is 0.5 m thick and is maintained on one side at T = 30°C, while the…

A: Data given- t= 0.5 m T1= 30°C q= 1200 W/m2

Q: The side of a home can be modeled as a plane wall. The wall is 12 centimeters thick. If the outdoor…

A:

Q: Consider a 1m long, 3.5mm diameter wire, with a thermal conductivity of 20 W/mK. If the wire has a…

A: Given data: ◆ The length and diameter of the wire: L = 1 m , d = 3.5 mm = 0.0035 m ◆ The thermal…

Q: A copper rod has an initial length 5.0 cm and a thermal expansion coefficient of 16 x 10-6 /K. It is…

A:

Q: A very long, rectangular cross-section block is made from metal with the following properties:…

A: Given Data: Thermal Conductivity k = 130 W/mK Density ρ=2771 kg/m3 Specific heat cp=703 J/kgK…

Q: Find the rate of heat transfer if the cylinder in a stainless steel rod. k = 15 W/m·K (8.7…

A: Givenk=15W/mKL=1mTh=200oCTc=100oCA=5cm2=5×10-4 m2

Q: Problem: A plane wall 6.0 cm thick generates heat internally at the rate of 0.3 MW/m³. One side of…

A:

Q: A steel bar 7 cm long is welded end to end to a copper bar 21 cm long. Both bars are insulated…

A: The temperature at the junction of the two bars is 28.12oC.

Q: 4-7 Two identical 7.5-cm cubes of copper at 425 and 90°C are brought into contact. Assuming that the…

A: To plot: The temperature of each block as a function of time, using lumped capacity method: Given:…

Q: section radius of a bar of metal of length L and uniform coefficient of thermal conductivity k is…

A:

Q: A mechanic needs to remove a tight fitting pin of material A from a hole in a block made of material…

A: GIVEN TOPIC- Thermal expansion of metals                         A mechanic needs to remove a tight…

Q: Many surgeries require the use of tools that cut through or remove parts of skeletal bones. These…

A: To calculate the amount of heat conducted along the bone during the cutting process, we can use the…

Q: Thermal conductivity measurement for good conductors using Searle's Method

A: serale,s method is used to measure thermal conductivity of matter by using steam.

Q: A pipe made of material A have an outside diameter of 30 cm and inside diameter of 25 cm. The pipe…

A: Given:r0=15 cmri=12.5 cmt=31 cmKA=70 W/m.KKB=11 W/m.KT1=1200 KT2=1100 KT3=350 KL=1.31 m

Q: Two metal bars are kept at the same temperature and are aligned with their nearer ends separated by…

A: Given, Distance between two bar = 1 mm αs=10-5 C-1Ls=4 mαI=1.2×10-5 C-1LI=5 m

Q: A five-celled multicellular section is shown in figure below. Determine the shear stress…

A:

Q: Define the thermal conductivities of some materials at room conditions

A: Thermal conductivity is a kind of intrinsic property of a substance that determines the ease with…

Q: Suppose the sphere in problem 2-15 is covered with a 1-cm layer of an insulating material having k =…

A: given data; ⇒layer thickness of insulating material (t)=1cm⇒conductivity of insulating material…

Q: 6. The heat generated in the circuitry on the surface of a silicon chip is conducted to the ceramic…

A: To findDetermine the temperature difference between the front and back of the chip.Giventhermal…

Q: A metal rod is 54.635 cm long at 25.2 °C and 55.406 cm long at 55.1 °C. Calculate the coefficient of…

A: Given:Initial length of rod, L1=54.635 cmInitial temperature of rod, T1=25.2°CFinal length of rod,…

Q: To find the thermal conductivity of a material, the following experimental setup can be prepared.…

A: Given Data:  For material A: Thermal conductivity  ka=390 Wm.K Constant temperature of heat sink…

Q: The turbine blades are assumed as a fin and we are trying to find the temperature at its tip. One of…

A: The turbine blades are assumed as a fin and we are trying to find the temperature at its tip.

Q: 2. A copper segment of length 1.8 m with the cross-sectional area of 0.03 m² is welded to an…

A: Given data:

Q: Find the steady-state temperature distribution in a metalic plate 20 cm by 60 cm if the two adjacent…

A: Given: The area of plate, A = 20 cm x  60 cm The temperature of adjacent sides of plates, Ts = 200…

Q: which of the following statements

A: Given; In a composite slab the temperature at the interface (Tinter) between two materials is equal…

Q: The cross section radius of a bar of metal of length L and uniform coefficient of thermal…

A: Given: Length = L Thermal conductivity = k r = (1 +x)1/2 ∆T=TH-TL

Q: Find the rate of heat transfer if the cylinder in a stainless steel rod. k = 15 W/m·K (8.7…

A: Given data: ● The thermal conductivity of steel rod: k = 15 W/m•K = 8.7 Btu/h•ft•°F ● The length of…

Q: T, 1000 K 350 K Heat flow 6k 4k Heat transfer through a composite wall of two sections, each having…

A: Given, Thermal conductivity of the left wall = k1 = 6k Temperature of the left surface = T1 = 1000 K…

Q: The following graph shows the thermal behavior of 2 kg of a material called Uniandesato undergoing a…

A:

Q: 3- A composite wall is shown in Figure. For element 1, let Kx = 5 W (m-°C), for element 2 let Kxx =…

A: Here we will use constant heat flow method.

Q: inner radius ri, outer radius r0, thermal conductivity k, according to this for the thermal…

A:

Q: 1. The two faces of a thin metal sheet that is 3 units wide and 5 units long are insulated, and the…

A: Two faces of thin metal sheet is insulated.Length of the plateWidth of the plateThe temperature of…

Q: A steel is 10 mm diameter and 2 m long. It is stretched with force of 20 kN and extends by 0.2 mm…

A:

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.