A compressor draws in 0.1 m/s of air at atmospheric conditions of 1.013 bar and 22°C and delivers it to a large receiver in which the air stabilises at a temperature and pressure 28°C and 310 kPa gauge. The air then discharges back to atmosphere through a converging diverging nozzle located in the side of the tank. Ignoring losses in the nozzle. Determine the:

A compressor draws in 0.1 m/s of air at atmospheric conditions of 1.013 bar and 22°C and delivers it to a large receiver in which the air stabilises at a temperature and pressure 28°C and 310 kPa gauge. The air then discharges back to atmosphere through a converging diverging nozzle located in the side of the tank. Ignoring losses in the nozzle. Determine the:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A converging nozzle having an exit diameter of 30 mmmm is connected to the large tank (Figure 1). The absolute pressure outside the tank is 102 kPakPa. If the temperature of the air in the tank is 20∘C∘C and the absolute pressure is 480 kPakPa, determine the mass flow from the tank. Express your answer using three significant figures.
The air in the reservoir has an absolute pressure of 450 kPa and a temperature of 30°C. The throat has a diameter of 50 mm. (Figure 1) Figure 50 mm 1 of 1 Part A Determine the greatest possible mass flow through the nozzle. Express your answer using three significant figures. m = Submit VAΣo↓vec Provide Feedback Request Answer ? kg/s Next >
The feed to a compressor is superheated steam at 310°C and 40 bar. It enters the compressor at a velocity of 17 m/s. The pipe inlet inside diameter is 0.25 m. The discharging pipe, after the compressor, has a smaller inside diameter and the discharge velocity is 120 m/s. The exit of the compressor is superheated steam at 350°C and 85 bar absolute. Heat loss from the compressor to the surroundings is 3 kW. Determine the compressor horsepower
Solve for the fuel consumption in g/min if air (h = 302 kJ/kg) and fuel (43,207 kJ/kg) enter the chamber with gases leaving it at an enthalpy of 616 kJ/kg. The air-fuel ratio in kg is seventeen. The house which uses the chamber for heating purposes requires 16.7 kW of heat.
As in the figure, a U-shaped pipe piece in the horizontal plane has water flow. At flange (1) total pressure pressure is 200 kPa, resulting in a mass flow of 40 kg/s to the pipe. At flange (2) , the total pressure is 150 kPa and the mass flow is 30 kg/s from the pipe. At (3) mass flow rate of 4 kg/sec from the section and 6 kg/sec from the (4) section to the atmosphere at 100 kPa pressure is discarded. With relative powers; Determine your Total Rx Ry forces at flange(1) and (2). ***Sections (1) and (2) are close enough ***density of water ??? = 1000 ??/?3 ***kinetic energy correction factor = 1,035 and momentum flow correction coefficient 1,025 *** mass flow = density*flow rate
Air at a temperature of 20°C and standard atmospheric pressure of 102 kPa flows through the nozzle into the pipe where the absolute internal pressure is 60 kPa. The nozzle has a throat diameter of d = 11 mm. (Figure 1) Figure 1 of 1 Part A Determine the mass flow into the pipe. Express your answer using three significant figures. ΤΙ ΑΣΦ ↓↑ vec m = Submit Provide Feedback Request Answer ? g/s
Hot gas enters the turbine at a pressure of 600kPa and a temperature of 1200K at a speed of 60m / s and exits at a pressure of 300kPa and a speed of 70m / s with a cross-sectional area of 0.125m ^ 2. Assume isotropic and constant flow and hot gas as a complete gas with a molar mass of 25kg / kmol and γ = 1.35 turbine power.
Air enters the room through a 200 mm diameter pipe and exits the fan into the ambient air through 240 mm pipe diameter. Pressure at the suction is 200 Pa below the atmospheric pressure, while 0.320 kPa at the exit. The fan delivers 500 m³/h of air and uses 0.08 kW of power, running at 1000 rpm. Find the efficiency of the fan. Select the correct response: 0.765 0.711 0.903 0.854
EMERGENCY!!!!! Calculate the input power of the compressor, which increases the helium gas from 150 kPa at 27 ° C to 400 kPa at 177 ° C. Helium gas goes to the compressor with a pipe with a cross section of 0.2 m2 at 10 m/s speed.