A compressed air vessel has an inside diameter of 2 m and a plate thickness of 12,5 mm. If the tensile stress induced in the plating is to be limited to 100 MPa, calculate for both the longitudinal and circumferential seams the pressure necessary to induce this stress. Take the longitudinal and circumferential joint 85% and efficiencies as 70% respectively. What would the actual allowable pressure be?

A compressed air vessel has an inside diameter of 2 m and a plate thickness of 12,5 mm. If the tensile stress induced in the plating is to be limited to 100 MPa, calculate for both the longitudinal and circumferential seams the pressure necessary to induce this stress. Take the longitudinal and circumferential joint 85% and efficiencies as 70% respectively. What would the actual allowable pressure be?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please show intermediate steps including free body diagrams, equations used, problem setup etc. so that your approach can be followed.
I need to solve this question for civil eng dep.
The figure shows the stress condition of an I-section beam at point A. With the Mohr circle method; 1-)Calculate the principal stresses, location and angle. 2-)Calculate the stress components that will affect the plane obtained by rotating the figure counterclockwise 25.
A hydraulic punch press is used to punch a slot in a 10-mm-thick plate, as illustrated. If the plate shears a determine the minimum force P required to punch the slot. Punch O 1051 KN O 766 kN O 649 kN O 717 KN O 979 KN Slug Plate 20 mm 75 mm Plan view of slug + a stress of 360 MPa,
ASAP NEED RIGHT COMPLETE SOLUTION !!!
what is the loading in pounds that you need to achieve vertical stress of 15 psi? Assume all the loading will put on the one-to-one ratio hanger. Assume a diameter of 2.5in.
Dianks A hollow cylindrical column is placed on a steel plate on a concrete pedestal, if it supports a compressive load of 0.75 MN as shown in the figure and the stress in the column is limited to 55 MPa, Calculate the desirable wall thickness of the column given that the diameter of the outside wall is 25 cm. Column Base plate ANS: mm (one decimal place)
2. A cylindrical pressure vessel is a fabrication from steel plating that fits to the following descriptions: Thickness = 25 mm Diameter = 500 mm Length = 2.5 m What maximum internal pressure can be applied if the longitudinal stress is limited to 160 MPa, and the circumferential stress to 80 MPa
A steel pipe 11 m in diameter is required to carry an internal pressure of 750kPa. If the allowable tensile stress of steel is 140 MPa, Determine the required thickness of the pipe in mm.
Please help me solve this problem. Need it asap. Thank you.
A hydraulic punch press is used to punch a slot in a 10-mm-thick plate, as illustrated. If the plate shears at a stress of 350 MPa, determine the minimum force P required to punch the slot. Punch 745 kN 942 kN 450 kN 872 kN 677 kN Slug Plate 20 mm 75 mm Plan view of slug
A cylindrical steel pressure vessel 400 mm in diameter with a wall thickness of 20 mm, is subjected to an internal pressure equal to the IMEP from item 1. Express your answers in MPa (a) Calculate the tangential and longitudinal stresses in the steel. (b) To what value may the internal pressure be increased if the stress in the steel is limited to 120 MN/m2?