A circular bracket with a diameter of 100 mm is fixed to a wall as shown in the figure below. Determine and draw the state of stresses in small infinitesimal cubic elements located at points M and N on the cross section A.

Q: O MPa and an axial stress of 325 MPa that act on an element imposes a bending stress of 250 MPa and…

A: Tangential stress is .Axial stress is .Bending stress is .Torsional stress is .

Q: A steel bar with a diameter of 100 mm is rigidly attached to the wall and carries the loads shown in…

A: Given: The diameter of shaft, d = 100 mm = 0.1 m The torque acting on the shaft, T = 8 kN.m The load…

Q: A single-piece bicycle crank is shown below under the following load: the rider pedals forward with…

A:

Q: shaft attached to 1900 N flywheel at distance of 400 mm from A and the shaft is rotated by a pulley…

A:

Q: 3. As in the figure, a ship can move both with the wind and with a diesel engine. your ship The mast…

A:

Q: The solid shaft shown in the figure below is fixed at one end and has a lever at the other. The…

A: Given data, Applied force, F = 840 N Distance, b = 110 mm Shear stress induced at point A on the…

Q: A solid bar has a diameter of 40 mm and subjected to the loadings shown in Figure 2. The supports at…

A:

Q: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

A: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

Q: The thin-walled pipe has an inner diameter of 2 in. and a thickness of 0.1 in. It is subjected to an…

A:

Q: The member shown below has a rectangular cross-section. Determine the state of stress that the…

A: Given Data: A Structural Member shown in a figure below Find: State of Stress at Point C and D

Q: A thick-walled cylinder with internal and external radii 86 mm and 166 mm respectively, is subject…

A: we have to determine the radial and hoop stress

Q: figure. Determine the required cross-sectional area of the bar BC if the allowable stresses are 100…

A:

Q: At an arbitrary cross-section, a - a the state of stress is obtained at various points (point 1 ~ 5,…

A:

Q: 7.2-5 The stresses acting on element A on the web of a train rail (see figure part a) are found to…

A:

Q: The Mohr's circle for a point near the base of a traffic pole is shown below. the center of the…

A: Consider the diagram shown below for the given Mohr’s circle.

Q: The stresses shown act at a point in a stressed body. Normal and shear stress magnitudes acting on…

A: Permissible stress is stress which produces due to pressure or forces which does not exceed the…

Q: An angled strut b = 6.2 in. thick is subjected to a force F = 55 kip and a uniformly distributed…

A: The values are F=55 kipq=23.5 kip/ft The thickness is b=6.2 in     To find out:- The principal…

Q: Couple-moment M is applied to the beam, which has a cross-section, as shown in the Figure. if M =…

A: According to the question M=458 N.m β=62° We need to find Stresses at point A ,B and D

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.