An angled strut b = 6.2 in. thick is subjected to a force F = 55 kip and a uniformly distributed load q = 23.5 kip/ft as shown below. Determine the principal stresses at points A, B, and C. 5 in. F +7.5 in.- q

Q: (a) If the rope is subjected to a vertical force of P = 500 N, determine the normal stress at points…

A: Diameter of the wooden post - 40 mm = 0.04 mVertical force, P =500 N

Q: Problem 4: The gap between the support and bar BC is 0.01 inches. If the magnitude of the force…

A:

Q: o solid cylindrical rod= C are welded together d as shown. The force Determine the average at the…

A:

Q: 105 GPa) has Prob 6. The rigid bar below is supported by a pin at E and two rods. The brass rod AC…

A: The rigid bar below is supported by a pin at E and two rods.The brass rod AC (Ebrass = 105 GPa= 150×…

Q: The rectangular bar has a width of w = 3.00 in. and a thickness of t = 1.50 in. The normal stress on…

A: (a) To find : The magnitude of load P. Given :  The width of bar is w=3.00 in. The thickness of bar…

Q: PB 3. A bar, show to the right, has a rectangular cross section of 3 in. by 4 in. and is fixed to…

A: To determine the reaction at the floor and the normal stresses in each of the three pieces.

Q: A rigid bar AB of length L = 1600 mm is hinged to a support at A and supported by two vertical wires…

A: Given that: LAB = length of bar AB = 1600 mm LAC = length of AC = 500 mm LAD = length of AD = 1200…

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ =…

A:

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 10 mm2.…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.