A Carnot cycle is executed using helium in a closed system between the temperature limits of 350 and 1200 K. The pressures before and after the isothermal compression are 150 and 300 kPa, respectively. If the net work output per cycle is 0.5 kJ, determine (a) the maximum pressure in the cycle, (b) the heat transfer to the helium

Q: pressure in the smaller pipe are provided. Determine the pressure after the expansion including the…

A: For pipe 1 Diameter D1 = 8cm = 0.08 m Velocity V1 = 10 m/s Pressure P1 = 410 kPa For pipe 2 Diameter…

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: here is a mixing device which produces sub-cooled liquid nitrogen at a pressure of 200 kPa as shown…

A:

Q: Water flows through a horizontal coil heated from outside. During its passage, it changes state from…

A: Inlet enthalpy (Hinlet) = 334.9 kJ/kgOutlet enthalpy (Houtlet) = 2726 kJ/kgInlet velocity (Vin) = 3…

Q: Air at 300 kPa and an average of 450 K is being heated as it flows through a rectangular conduit of…

A: The rate of heat transfer for unit area is called as heat flux normal to the direction heat flowing.…

Q: Air enters a diffuser at 102 KPa , 57 Celcius , and 285 m/s and exits at 303 KPa , 10 Celcius , and…

A: Let the inlet conditions be represented as ‘1’ and outlet conditions by ‘2’.   Given specifications…

Q: A counterflow heat exchanger with both fluids unmixed is used to heat water (cp = 4.181 kJ/kg.K)…

A: Mass flow rate of water =2.0 kg/s Specific heat capacity of water, CP,w=4.181 kJ/kg.K Inlet…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

A: In the process of refrigeration, there is the absorption of heat at a lower temperature which is…

Q: 2. Consider a cylindrical nuclear fuel rod of length L and diameter D that is encased in a…

A: Given below solution Explanation:Step 1: Step 2: Step 3: Step 4:

Q: There is a 4" O.D. vertical pipe made of 316 stainless steel. Calculate the heat flux (q/A) per unit…

A: Heat flux for radiation and free convection it be calculated.

Q: A horizontal steam pipe 20 m long, 50 mm internal diameter, 60 mm outside diameter loses 13.5 KW…

A:

Q: Initially, a piston device contains 0.55 m³ of saturated water vapor at 300 kPa and at this state,…

A: Consider a piston device containing 0.55 m3 saturated water vapor at 300 kPa at initial state. 400…

Q: Problem 3 A heat engines operates between a lake's surface water at a temperature of 300 K and water…

A: Given, The surface temperature, T1 = 300 K The temperature of the water, T2 = 285 K The power…

Q: 45 kg/h liquid propylene will be cooled from 300 K to 288 K by chilled water through a shell and…

A: Heat capacity of liquid propylene at 294 K is 2.6 kJ/kg-KCp-pl = 2.6 kJ/kg-KFlow rate of liquid…

Q: Cold water with a mass flow rate of 9800 kg/h is heated from 40 to 115 oC in a countercurrent flow…

A: As per Bartleby guidelines we are supposed to answer only first 3 sub parts. Kindly repost other…

Q: Water at a rate of 4000 kg/hr is heated from 30 °C to 80 °C by pressurized water that enters the…

A: Given information: 2 shell and 4 pass shell and tube heat exchanger is used to heat water using…

Q: 2) A 0.68 m³ rigid tank contains refrigerant-134a initially at 100 kPa and 40 percent quality. Heat…

A: Given:   Volume of the rigid vessel, V = 0.68 m3 Initial pressure of R-134a, P1 = 100 kPa Quality of…

Q: Argon gas in an insulated plasma deposition chamber with a volume of 2 L is to be heated by an…

A: Volume = V = 2 L= 0.002 m3, P = 1.5 Pa T = 300 K, We know that, R = ldeal gas constant = 8.314…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

A: The equation for C.O.P of refrigerator is given by:- C.O.P=TCTH-TC---(1) Where, Tc (condenser…

Q: A copper pipe, 3 cm in outer diameter and 1.5 cm in inner diameter, carries R-22 refrigerant at a…

A: Given data: Inner diameter of pipe = 1.5 cm Outer diameter of pipe = 3 cm Temperature of refrigerant…

Q: 5. Convection Outside DUE 9/7. Aniline is to be cooled from 200 to 150 °F in a double-pipe heat…

A:

Q: Oil at 500K is to be cooled at 5000K in a counter current exchanger using cold water available at…

A: In the question, the mass flow rate of oil is given as 5000 K. But it has to be 5000 kg/hr. The mass…

Q: Consider a location where the surface temperature is 27°C and the temperature at a depth of 750 m is…

A: For a detailed solution, please see the attached files.

Q: Water at 2.5MPa and 200C is heated at constant temperature up to quality of 80%. Find (a) the of…

A:

Q: A 40 kg water heater starts leaking with a rate of 1 kg/min. No water is added. If heat transfer…

A: Given: Mass = 40kg Mass remaining = 25kg Rate of leakage = 1kg/min

Q: (For numbers 4 to 10) A double-pipe heat exchanger (counterflow operation) having an area of 100 m²…

A: Given that, Area A = 100 m2 The mass flow rate of water mc = 5 kg/s The inlet temperature of water…

Q: (For numbers 4 to 10) A double-pipe heat exchanger (counterflow operation) having an area of 100 m²…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Q3. A Carnot system operates between temperatures 500 "F and 100 °F. Its efficiency may be increased…

A:

Q: of 15000 W/m2. Water flows through the tube at a rate of m = 1 kg/s, and its inlet nean temperatures…

A: GivenTube diameter D=70 mm=70×10-3mHeat flux q.=15000 W/m2mass flow rate m=1kg/s.Mean inlet…

Q: a. Compute the Jakob number, Ja = 2,A b. The effective latent heat, li h(1+0.68Ja) (kJ/kg) c. The…

A: Given that  Temp,T1 =60 c Length = 2 m mass flow rate ,m =300 kg/hr hfg = 2257 kj/kg Cpj = 4.217…

Q: Find the two-dimensional temperature distribution T(tz) under steady state condition. Where, To-20…

A: T0 = 20 C = 293 K T(L) = 1000 C = 1273 K Density (p) = 800 kg/m^3 k = 200 W / m K Cp = 2500 J/ kg K…

Q: The cooling limit temperature T1 is 11 °C , the warm water temperature at the cooling tower inlet…

A:

Q: Initially, a piston device contains 0.55 m³ of saturated water vapor at 300 kPa and at this state,…

A:

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: 2. A vapor-compression refrigeration system operates on throttling expansion. The refrigerant is…

A: The refrigeration system flow diagram is obtained. This system contains a condenser, compressor,…

Q: Consider the compression of air from 10³ Pa at 27°C to 3x 10° Pa in an ideal two stage compressor…

A:

Q: Q2/ A gas turbine cycle has the following working parameters ( ideal Bryton cycle): - The…

A: Given:  Max. Temperature of Cycle = 1300 K and Min. Temperature = 300 K and compression ratio or…