A car owner observed that when the air temperature of his car tire is at 25°C the gage reads 210 kPa. The pressure then rises when the temperature in the tire rises to 50°C for which the volume of the tire is 0.025 m³. Determine the amount of air (in kg) that must be relieve to restore pressure to its original value. Given: Atmospheric pressure is at 100 kPa Hint: Find the pressure when temperature rises to 50°C reduce to 2 significant numbers

A car owner observed that when the air temperature of his car tire is at 25°C the gage reads 210 kPa. The pressure then rises when the temperature in the tire rises to 50°C for which the volume of the tire is 0.025 m³. Determine the amount of air (in kg) that must be relieve to restore pressure to its original value. Given: Atmospheric pressure is at 100 kPa Hint: Find the pressure when temperature rises to 50°C reduce to 2 significant numbers

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

See the sketch below from our textbook (not to scale!), where the liquid in the open-top tank and pipe is water, and the manometer is partially filled with mercury (from "B" around to "C"). You should know the density of water, and assume mercury has density 13.5x that of water. What is the pressure at "A" if h = 200 mm? AQ B E 400 mm C150 mm 100 mm 200 mm Mercury
Show complete solution and formula used.
I need the answer as soon as possible
As shown in the figure, determine the gage pressure on the bottom of the tank in kPa. Considering the total gage pressure at the bottom of the tank what will be the absolute pressure if the barometric pressure if 725 torr?
Q.9 Fluid Properties If the surface tension at the air-water interface is 0.078 N/m, estimate the pressure difference between inside and outside of an air bubble of diameter 0.015mm in water. ( Considering outside pressure as atmospheric)
the surface tension of water in contact with air at 20c is given as 0.0716 n/m . the pressure inside a droplet of water is to be 0.0147 n/cm2 greater than the outside pressure, calculate the diameter of the droplets of water?
show complete solution and diagram
Please answer
Given a manometer that uses water instead of mercury, determine the height of the column of water in the manometer if the pressure in the container is 2 atm. Assume normal atmospheric pressure.
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3. pls answer asap thank you
The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B