A cantilever beam 50 mm wide and 80 mm deep is 2 m long. It carries a uniformly distributed load over the entire length along with a point load of 10 kN at its free end. Find the slope at the free end when the deflection is 7.5 mm at free end. Take E = 200 GPa. Report your final answer with an accuracy of 4 decimal places.

Q: 3. A 12 ft cantilever beam is subjected to a uniformly distributed load at the entire span and a…

A: Double integration method: This method represents the series of simple loads which give deflection…

Q: The fixture shown in Figure 5 is fixed at point A and free at point C. The frame is made from a…

A: Given data  b = 50 mm  h = 75 mm  E = 200 GPA  Ignore axial and shear deformation  Find vertical…

Q: Determine the maximum deflection of the solid circular shaft illustrated in Figure 3. The shaft is…

A:

Q: For the beam loaded as shown in the figure below, determine the following unknowns using any…

A:

Q: Part 2: By Super Position Consider the simple supported beam shown in the Fig. a. Determine the…

A:

Q: 3 KON 2+ Find Force in BD, B 4M 3M A only by force method jok C ← 10 Truss Members 3 5 KW

A: Solution: Free body diagram:

Q: es a uniformly distributed load of 5 kN/m toget s free ends. 2 kN w = 5 kN/ m. 2 m 8 m the…

A:

Q: E 150 GPa and I = 65.0(106) mm¹. (Figure 1) Figure 1 10 kN 10 kN-m of 1 -3 m > Determine the slope…

A:

Q: Q1/For a simple beam loaded as shown in Figure 1. Determine the slope and deflection at the position…

A: E = 2 × 105 N/mm2 I = 5 × 108 mm4 Determine the slope and deflection at midway of the beam. Let's…

Q: Determine the ff. unknowns on the beam shown using CONJUGATE BEAM METHOD. Consider 250 mm x 250 mm…

A: M/EI diagram in the real beam is loading in the conjugate beam Fixed support in real beam = free end…

Q: A

A:

Q: shown in the figure, a uniform load (w = 300 lb/ft) is applied on a beam (L = 8 ft) with both ends…

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.