a) Calculate the vol of gases leaving the apparatus per entering. b) wt. of Cl2 absorbed per 100ft° of gas entering. (CLO2+PLO1) Leaving temperature is 99°C. P-755mmHg P.P of Chlorine Absorber 0.9mmHg Chlorine + inert gases P-755mmHg T-89 P.P of Chlorine -67mmHg CAC12

Q: Consider a system of 6-in. ID vertical pipe with a falling film of water on the wall. Estimate he…

A: Given:  mass flow rate of water given i m*  =1570 lb/hr  diameter of pipe d = 6 in = 0.1524…

Q: A solution is made by dissolving 0.501 mol of nonelectrolyte solute in 797 g of benzene. Calculate…

A:

Q: he barometer shows a value of 740 mm Hg; dry bulb temperature 40 ° C; wet bulb temperature is 30 °…

A: Total pressure= 740mm =(740*0.00133) = 0.9842Bar Dry bulb temperature = 40oC = 313K Wet bulb…

Q: The glycerine with a mass flow rate of 700kg/h passes through a pipe with an inner diameter of 30…

A: glycerine mass flow rate =700kg/h  pipe inner diameter Di=30 mm length of heated section L=2.5m…

Q: A simple atmospheric distillation tower as shown in the Figure below have a capacity of 1200…

A: It is given that, the distillation tower has a capacity of  Flow rate of steam vapor  at…

Q: The penetration coefficient of A in B is reported at 26 °C, 0.258 cm2 and at the other temperature…

A: Given: Penetration coefficient D1 = 0.258 cm2/sec at T1 = 26 oC and Penetration coefficient D2 =…

Q: 2. At 25°C the surface tension of benzene is 28.9 mN/m and its molar volume is 89.2 cm³/mol.…

A: Given Data :At 25 degree C the surface tension of benzene is  Molar volume of benzene((Vm)) is  -…

Q: In absorption, the absorbent is stripped to an extent that depends on its K-value. In stripping, the…

A: The type of process which is taking place along with the reason in the given diagram is to be…

Q: A phase change graph is shown below. What is the freezing point for this substance?

A: Given, The heat released during boiling and freezing is at a constant temperature. As the…

Q: temperature

A: Given: The results of measurement of air temperature obtained a dry ball temperature of 34 oC and a…

Q: Problem 1 Estimate the time required to evaporate 5% of a solid naphthalene sphere (moth ball)…

A:

Q: the tube, and the wall temperature is maintained at 55°C. What fraction of the vapour will condense…

A:

Q: 1.)   A glass bulb contains 250 grams of nitrogen gas at a temperature of 80oC and at a pressure of…

A: Given that T = 25 C =25+273.15 = 298.15 Kdiameter,d = 395  pm P = 1nTorr According to bartleby…

Q: If the air (35 degrees celsius, 1 atm, 760 mmHg) contains 3% (volume fraction) water, what is the…

A: To calculate the relative humidity (RH) and the changes in water content with temperature, we start…

Q: A mixture of air and water at a temperature of 25°C flows up through a vertical tube with a length…

A:

Q: Using the psychrometric chart from the notes determine the a. wet bulb temperature and the b.…

A: Given data: Dry bulb temperature = 82 0C Relative humidity = 20 %

Q: (a) Assume that there is a negligible thermal gradient in the wall of the container (dT/dr is…

A: Consider a spherical conatiner is used to store reacting chemicals, whichresults in a uniform heat…

Q: The following stream is at 100 psia and 190F. Perform and isothermal flash calculation to determine…

A: Given, z1=0.2    K1=15.0z2=0.3    K2=3.0z3=0.3    K3=0.75z4=0.2    K4=0.005

Q: elevation of the boiling point

A:

Q: 2. Calculate the speed of sound in helium gas at 500°F.

A:

Q: In a shower, cold water at 10 oC flowing at a rate of 5 kg/min is mixed with hot water at 60 o C…

A: Given: Temperature of cold water Tc = 10 oC Flow rate of cold water mc = 5 kg/min = 560 kg/sec…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.