A bicycle wheel has a diameter of 65.0 cm and a mass of 1.77 kg. Assume that the wheel is a hoop with all of the mass concentrated on the outside radius. The bicycle is placed on a stationary stand and aresistive force of 124 N is applied tangent to the rim of the tire.(a) What force must be applied by a chain passing over a 9.01-cm-diameter sprocket in order to give the wheel an acceleration of 4.57 rad/s²?397XYour response differs from the correct answer by more than 10%. Double check your calculations. N(b) What force is required if you shift to a 5.67-cm-diameter sprocket?KNNeed Help?Read It

The net torque acting on the wheel is given by τ=Iα where I=moment of inertiaα=angular…

Answered: A bicycle wheel has a diameter of 65.0…

Similar questions

Fy Ex The plant in the picture has mass of 30 kg, and is hanging at a distance of 1.8 meters from the wall. The horizontal rod has mass of 7.8 kg. Assume that its weight is evenly distributed, therefore it can be treated as a single force at the center of mass. The rod is 2 meters long, and there is a cable at a 38° angle supporting it at the end. Using the wall as the axis of rotation, find the magnitude of the downward torque, from both the weight of the rod and the weight of the plant.
A force of 290 N acts tangentially on the rim of a wheel whose radius is 25 cm. Find the torque that is being applied to the wheel.
At the presentation ceremony, a championship bowler is presented a 1.44-kg trophy which he holds at arm's length, a distance of 0.655 m from his shoulder joint. (a) Determine the torque (in N - m) the trophy exerts about the shoulder joint when his arm is horizontal. (Enter the magnitude only.) |N•m (b) Determine the torque (in N · m) the trophy exerts about the shoulder joint when his arm is at an angle of 37.0° below the horizontal. (Enter the magnitude only.) N. m
An m 10.8kg mass is attached to a cord that is wrapped around a wheel of radius r= 11.9cm (see the figure below). The acceleration of the mass down the frictionless incline is measured to be a = 2.17m/s^2. Assuming the axle of the wheel to be frictionless, and the angle to be 8 = 36.5deg determine the tension in the rope. Submit Answer Tries 0/10 m Determine the moment of inertia of the wheel. ) Submit Answer Tries 0/10 Determine angular speed of the wheel 2.09s after it begins rotating, starting from rest.) Submit Answer Tries 0/10
A potter's wheel—a thick stone disk with a radius of 0.570m and a mass of 118kg—is freely rotating at 41.0rev/min. The potter can stop the wheel in 5.30s by pressing a wet rag against the rim and exerting a radially inward force of 68.1N. Calculate the effective coefficient of kinetic friction between the wheel and the rag.
A hoop of mass 3.00 kg and radius 1.00 m is moving at 3π rad/s across a horizontal surface. The coefficient of friction between the hoop and the surface is 0.65. Calculate how far the hoop will travel before it comes to rest.
A simple pendulum consists of a small object of mass 3.5 kg hanging at the end of a 2.0-m-long light string that is connected to a pivot point. (a) Calculate the magnitude of the torque (due to the force of gravity) about this pivot point when the string makes a 7.0° angle with the vertical. (b) Does the torque increase or decrease as the angle increase?
If two other bigger children are going to push on the merry-go-round rim to bring it from rest to 45.0 rev/min in 39.0 s, with what force magnitude must each child push?
A stone is suspended from the free end of a wire that is wrapped aroundthe outer of a pulley as shown. The pulley is a solid cylinder with mass 10.0 kgand radius 30.0 cm. You measure that the stone travels 12.6 m in the first 3.00s starting from rest. What is (a) the tension in the wire and (b) the mass of thestone?
In the figure, a uniform sphere of mass m = 0.551 kg and radius r = 0.139 m is held in place by a massless rope attached to a frictionless wall a distance L = 2.31 m above the center of the sphere. Find (a) the tension in the rope and (b) the force on the sphere from the wall.
A jet transport has a weight of 2.14 x 106 N and is at rest on the runway. The two rear wheels are 17.0 m behind the front wheel, and the plane's center of gravity is 10.5 m behind the front wheel. Determine the normal force exerted by the ground on (a) the front wheel and on (b) each of the two rear wheels.
A block of mass m1 = 2.05 kg and a block of mass m2 = 6.35 kg are connected by a massless string over a pulley in the shape of a solid disk having radius R = 0.250 m and mass M = 10.0 kg. The fixed, wedge-shaped ramp makes an angle of ? = 30.0° as shown in the figure. The coefficient of kinetic friction is 0.360 for both blocks. (c) Determine the tensions in the string on both sides of the pulley.