A beaker of water has a radius R = 0.06m and a contact angle 0 = 3.6 degrees. Calculate the surface tension force around the interface of the water with the perimeter of the beaker. Determine the horizontal and vertical components of the force.

Q: 1. An axial compressive load of 50 tons is applied to a metal bar of square section 2 in. by 2 in.…

A: Hjh

Q: 1. A solid shaft ABCD of diameter d is fixed at A and subjected to torques applied at equally spaced…

A: Since, we answer only three sub-parts at a time so we will answer the first three sub-parts. Please…

Q: Consider a square bar 30 mm on side and 2.5 m long, having a material yield point 254 (in MPa). An…

A:

Q: The rubber band AB has an unstretched length of 1m. If it is fixed at B and attached to the surfaced…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: 2. The state of plane stress at a point is represented on the element shown in the figure below. (a)…

A:

Q: A square steel bar of dimension 50 mm x 50 mm x 150 mm is subjected to an axial load of 250 kN.…

A:

Q: 30 0.9 m 1.2 m •At depth h the pressure is pgh. •Force on a small element = pressure x area

A: To determine hydrostatic pressure force on submerged plate.   Given, Angle between the plate and the…

Q: : Calculate and sketch the normal stress distribution acting over the cross section at section a-a.…

A:

Q: 25. The area coefficient of thermal expansion is equal to two times the value of linear coefficient…

A: Given: It is asked to choose if a statement is true or false.

Q: The kinematic viscosity of the oil filled between two concentric vertical 150 mm long cylinders is…

A: Given data in question  Length 150 mm Diameter 0.2 m Kinematic viscosity  Specific gravity of oil…

Q: Q.43 Consider a steel (E = 200 GPa) column hinged on one side and fixed on the other side. Its…

A: Given data, E=200 GPa, Height (h) =1.5 m Cross-section = 20 mm×25 mm

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.