A balanced, three-phase, positive sequence source, supplies power to a balanced wye-connected load.  Additional information given for this system are as follows:  |Zan| = 106 ohms; and the total apparent power = 1996 volt-amp, with 0.90 power factor lagging. For the system, determine the magnitude of Van in volts.

Q: I- Purely Inductive Load 1. Sketch a three-phase 100VAC RMS phase-voltage, Wye (Y) Connected power…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 7. For the circuit below, calculate the value of Zz for maximum average power transfer to the load.…

A: Calculate the value of Z for maximum average power tyansfer to the load. In addition, deternmine the…

Q: what is the minimum voltage? a) 129 kvp b) 14 kVp c) 86 kVp d) 21 kVp e) 10.7 kVp ge ripple

A: Given data, Output voltage VO=150 V. Ripple voltage Vr=14 %.

Q: HW 10 An integral cycle circuit with source voltage Vs = 100 sin(wt) and resistive load 100, if the…

A: Bartleby has policy to solve only first question and it's first 3 subparts.  For the solution of…

Q: For the circuit shown. If the peak voltage V, -120 L 20 V, X = 4.Y=2, and Z = 4. Answer the…

A:

Q: 2. A three phase delta connected balanced resistive load is connected to a three phase delta…

A: For delta connected load line current =3×phase current power consumed=3*I2*R. Energy= power *time

Q: What is the DC resistance per phase? What is the effective resistance per phase?

A:

Q: Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a…

A:

Q: Determine the ripple factor and the average load current of the given circuit shown. Finalize answer…

A:

Q: Calculate the signed hexadecimal (base 16) value for the given floating point number. Show the steps…

A:

Q: 18: A series resistive inductive load is energized from a 240V(RMS), 50HZ single phase A. supply,…

A: Given a series RL circuit having, Energized voltage, V = 240 V (rms) Frequency, f = 50 Hz Active…

Q: Q2/A/ The 2MW load operating with 0.8 lagging power factor. To improve the power factor to 0.95 a…

A:

Q: The 3-phase power and line-to-line voltage ratings of the el figure are as follows: Generator G 160…

A:

Q: How did he come up with the idea? And why didn't he draw the circle?

A: Asked to draw the phasor diagram of star connected balanced load with currents.

Q: A three phase motor can be regarded as Balanced "Wye " load. A three motor draws 5.6 KW when the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A Sketch the circuit diagram of a star connected three phase load and mention the line and phase…

A:

Q: VA rms() IA LA) PA (W) QAVAR (rad ts) (rod is)

A: Since you have posted a question with multiple sub-parts, We will solve the first three parts for…

Q: A starconnected, 5000 V, 3-phase altemator is supplying 3,000 kW at power factor of 0.8. Calculate…

A: Also power in 3 phase system = 3×phase current2×resistance.   In Star connected system , Phase…

Q: Three Impedances each of (12 - j20)0 are connected in mesh across a three-phase 415V ac supply.…

A:

Q: ree delta-connected bad impedances, Zab = 82, 2pc = 8 - j6 12, and = 8 + j6 2, are connected to an…

A:

Q: 6. A Y-connected load with an impedance of 12 - 15 N per phase is con- nected to a balanced…

A: In this question, we need to determine the voltages , currents and powers in the load. source is…

Q: Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a…

A:

Q: . Calculate the voltage regulation of a 230V, three phase alternator supplying the following loads…

A: As per our policy i have attempted first three sub-parts Given data:  Voltage regulation is: 230 V

Q: Write a conclusion about : MODELLING OF 3 PHASE POWER SYSTEM USING MATLAB SIMULINK SOFTWARE .

A: Given: Write a conclusion about: MODELLING OF 3 PHASE POWER SYSTEM USING MATLAB SIMULINK SOFTWARE.

Q: A 25 kVA, 240 V single phase source supply the rated power at the rated voltage to a motor at 0.8…

A: As we have given : S=25 kVAV=240 Vcosϕ1=0.8cosϕ2=0.9

Q: A SINGLE-PHASE 230 AC, 60 HZ POWER SUPPLY FEEDS A 2400 WATTS AIR CONDITIONING SYSTEM, WITH A POWER…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: A balanced load is connected in star across a 3 phase 415V 50Hz supply. The load consists of a coil…

A: Given data,3 phase Supply voltage V=415V Frequency (f)=50Hzload consists of a coil of resistance…

Q: For a system with total complex power of 10000 + 7500j VA, nominal voltage of 250 angle 30 deg. and…

A:

Q: A 6.6 kV, 6 MVA, Y-connected, 3φ alternator has an effective ac resistance of 0.436Ω between…

A:

Q: n 3-phase alternator, the change of terminal voltage from no load to full load is more in case of…

A:

Q: Referring to the Figure 2, compute the following values, given that the operating frequency is 60Hz…

A: Given that Voltage E= 120 V Frequency, f=60 Hz A circuit is shown below. Find inductive reactance,…

Q: A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of 400…

A:

Q: (a) A single phase, unity power factor load takes 60 A at 25 kV. Using a base voltage of 65 kV and…

A:

Q: A charge of 3500 VA to a with a power factov of 0,70 leading, connected of 50 Hz and Voltage of 23O…

A: The solution can be achieved as follows.

Q: Three loads connected in parallel across a 1000-V (RMS), 60-Hz single-phase source. Load 1:…

A:

Q: A voltage of 200 253"8' is applied across to impedances in parallel. The values of impedances are…

A: Given data, Voltage V=200∠53.80 Impedances are given Z1=12+j1000 Ω, Z2=10-j20 Ω

Q: Calculate the necessary phase voltage amplitude for turbine output, if active power is 3 MW,grid…

A:

Q: Prob.5) A single-phase 100 kVA, 600 V, 50 Hz, 2 poles alternator has effective resistance and…

A: Given  Data:SL = 100 kVAVL = 600 VRa = 0.72 Xs = 0.18 Power Factor = 0.75 leadAnd Load current,  IL…

Q: 5. A three-phase power system consists of a wye-connected generator connected to a wye-connected…

A: A generator's combined real power and reactive power output make up its overall complex power.…

Q: A 5 kVA, 208 V, three-phase AC is connected in wye. Determine: the voltage of each coil of the phase…

A: In this question,  We need to determine the voltage of each coil of the phase winding, coil current…

Q: A single phase distībutor AB has a total impedance of (0-1+j0-2) ohm. At the far end B, a curent of…

A:

Q: Explain what os Rectifier? Also explain Half wave and Full wave Rectifiers with neat diagram

A: A rectifier is a device that changes over a swaying two-directional exchanging current (AC) into a…

Q: Can you help me provide recommendations to improve harmonics and flicker- in three phase power…

A: The harmonics in a system can be explained as the integral multiple of the fundamental frequency.…

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.