a) A bullet of mass 0.100 kg travels with a speed of 70.0 m/s. It impacts a block of mass 0.950 kg which is connected to the end of a spring of stiffness 90.00 N/m. The bullet remains in the block after the collision. lellellll To what maximum distance does the spring compress from its equilibrium position?

a) A bullet of mass 0.100 kg travels with a speed of 70.0 m/s. It impacts a block of mass 0.950 kg which is connected to the end of a spring of stiffness 90.00 N/m. The bullet remains in the block after the collision. lellellll To what maximum distance does the spring compress from its equilibrium position?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A spring with relaxed length 0.30 m and spring constant 1.8 N/m rests horizontally on a frictionless table and is anchored frmly to a wall on one side. You press a 400 g block into the other side until the spring length is 0.16 m and then let go. a.) What will the momentum of the block be when it departs from the spring? (Assume contact ceases when the spring is relaxed.) b.) If the table were no longer frictionless and the block-table interface had a kinetic coeffcient of friction of 0.1 what then would the momentum of the block be when it departs from the spring?
A super ball of mass 0.1 kg is dropped from a height of 3.0 m above the floor. It bounces off the table and rises to a height of 2.6 m. This is an elastic col- lision similar to the carts with springs in your lab. a. Calculate the velocity of the ball the instant before it reached ground level, V₁. Hint: You can use conservation of mechanical energy and the height it is dropped from to get this velocity. +x-DIRECTION Now use conservation of energy to calculate the velocity the ball must have after the collision at the instant it leaves the ground to reach a height of 2.6 m. Figure 8-21 C. These velocities are the initial and final velocities for the collision with the ground. Use them to calculate the change in momentum of the ball. Don't forget the directions are not the same so one will be +₂ the other --. b. 2.0 m
An 11,000-kg freight car rests against a spring bumper at the endof a railroad track. The spring has constant k = 0.32 MN/m. Thecar is hit by a second car of 9400-kg mass moving at 8.5 m/s, andthe two couple together. Find (a) the maximum compression ofthe spring and (b) the speed of the two cars when they reboundtogether from the spring.
6
2. A 1.2 kg cart moving at 6.0 m/s [E] collides with a stationary 1.8 kg cart. The head-on collision is completely elastic and is cushioned by a spring. a. Find the velocity of each cart after the collision. b. The maximum compression of the spring during the collision is 2.0 cm. Find the spring constant.
Both answer are wrong
A rifle bullet with mass 4.00 gm strikes and embeds itself in a block with mass 0.996 Kg that rests on a frictionless, horizontal surface and is attached to a coil spring. The impact compresses the spring 15.0 cm. Calibration of the spring shows that a force of 0.750 N is required to compress the spring 0.75 cm. What was the bullet's initial speed? www 281 m/s 375 m/s 212 m/s 454 m/s
An object of mass 3.0 kg is held in placespring with spring constant k = 185 N/mrests on a horizontal plane surfacewithout turning on. The other end of the springconnected to the wall. Another thinga mass of 1.6 kg is thrown towards a mass of 3.0kg and pound it with an elastic impactperfect. Maximum spring compression is 80cm. Determine the speed of the incoming mass (mass1.6kg).
2. Cart 1 of mass m = 0.50kg fastened to a spring of spring constant k = 14N/m is pushed 15 mm in from its equilibrium position and held in place by a ratchet (Fig. 2). An identical cart 2 is launched at a speed of 0.10m/s toward cart 1. The carts collide elastically releasing the ratchet and setting cart 1 in motion. After the collision, cart 2 is immediately removed from the track. a What is the maximum compression of the spring? b How many seconds elapse between the instant the carts collide and the instant the spring reaches maximum compression? _JM www cart 1 cart 1 Figure 2 cart 2
2. A 1.2 kg cart moving at 6.0 m/s [E] collides with a stationary 1.8 kg cart. The head-on collision is completely elastic and is cushioned by a spring. b)The maximum compression of the spring during the collision is 2.0 cm. Find the spring constant. do it correctly please and thank you
In the figure, block 2 is at rest on a frictionless surface and touching the end of anunstretched spring of spring constant ?. The other end of the spring is fixed to the wall. Block 1,traveling with a speed ?0, collides with block 2, and the two blocks undergo an elastic collision.When the block 2 momentarily stops, by what distance is the spring compressed? Your resultshould be a function of the masses of each block, the speed of block 1, and the spring constant.
5. A bullet with mass me hits a ballistic pendulum with length L and mass mw and lodges in it. When the bullet hits the pendulum it swings up from the equilibrium position and reaches a height y. Determine the bullet's velocity. Before collision 0₁ ma Immediately after collision mw Top of swing