A 75 mm diameter orifice discharges 0.023 m3/s of liquid under a head of 2.90 m. The diameter of the jet at the vena contracta is found by calipering to be 66.25 mm. Compute the coefficient of discharge. Determine the coefficient of contraction. Find the coefficient of velocity.

Q: Question (2): Determine the head in the region between the two materials and the discharge in…

A:

Q: Air (1.23 kg/m³) flows past an object in a 2-m-diameter pipe and exits as a free jet as shown in the…

A: Given, ρ = 1.23 kg/m3 D = 2 m   NOTE : As per guidelines, first 3 parts are solved. Request you to…

Q: Piezometric tubes are tapped into a pipe section as shown in the figure below. The liquid is…

A:

Q: For the hydraulic system shown below. 1- Determine the resistance and discharge of each pipe. CLO1,…

A: Given, PA=100 KPa Head=PA9.81=10.19 m Net head =10.19+40=50.19 m Let head loss in pipe 1 =△h1 Head…

Q: Q4. The tank is filled with aqueous ammonia (ammonium hydroxide) to a depth of 3 ft. The remaining…

A:

Q: A 160 mm pipe branches into a 100 mm pipe and a 50 mm pipe, as shown in the figure. In both pipes,…

A: Step 1: the required flow rate is 400L in 7 minutes, that is, (400*0.001)/(7/60) =3.4286 m3/s Step…

Q: Calculate the pressure difference between the 2 points shown on the figure below (P1 - P2)? Fluid in…

A: Given :-       The pressure difference between 2 points ( P1-P2)           SG =13.6           Cross-…

Q: Q.2.8 MASS FLOW AT A PIPE JUNCTION Consider the s. tv low in a water pipc joint shown in the…

A:

Q: Problem No. 7 A hollow shaft that has 100 mm outside diameter and 80 mm inside diameter is used to…

A:

Q: Describe about the piston with pressure chamber in the statnamic test.

A: The statnamic test is the tests which are used for determining load carrying capacity of deep…

Q: A 3 cm orifice plate is placed within a 4 cm pipe in which methanol at 20 °C (SG = 0.7884 and…

A: Diameter of the orifice = d = 3m   Diameter of the pipe = D = 4m   Specific gravity of the methanol…

Q: Ex. For the square loop shown: 1. find the discharge in all the pipes. All pipes are 1 km long and…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.