A 60 Hz, single-circuit, three-phase transmission line is 150 mi long. The line is connected to a load of 50 MVA at a logging PF of 0.85 at 138 kV. The line impedance and . Imittance are z= 0.7688477.4 0/mi and y = 4.5239 x 10-64 90* S/mi, respectively. Determine the following: (a) Propagation constant of the line (b) Attenuation constant and phase change constant, per mile, of the line (c) Characteristic impedance of the line (d) SIL of the line (e) Receiving-end current (f) Incident voltage at the sending end (e) Reflected voltage at the sending end

A 60 Hz, single-circuit, three-phase transmission line is 150 mi long. The line is connected to a load of 50 MVA at a logging PF of 0.85 at 138 kV. The line impedance and . Imittance are z= 0.7688477.4 0/mi and y = 4.5239 x 10-64 90* S/mi, respectively. Determine the following: (a) Propagation constant of the line (b) Attenuation constant and phase change constant, per mile, of the line (c) Characteristic impedance of the line (d) SIL of the line (e) Receiving-end current (f) Incident voltage at the sending end (e) Reflected voltage at the sending end

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

I need the answer as soon as possible
Which of the following USB version has the transfer mode called Super Speed? Select the correct response: USB 4.1 USB 3.1 USB 4,0 USB 3.0
25
Answer it pls.
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
Are the following statements correct or wrong? Justify your answer. (a) GTO requires very low current applied to its gate to be turn off. (b) IGBT is a voltage driven device. (c) BJT is more efficient than IGBT in high power applications. (d) Thyristors are used only for low voltage, low current applications.
I need the answer as soon as possible
Subject : Cercit *Please answer as fast as you can ?? thanks
no handwritten, explanation in detail for QPSK as mentioned. don't copy paste from other sites
The hex number E843 is ___________ bytes long. Give the answer as a number such as "8".