These multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final answer. 9) According to sampling theorem a. Ts is equal to 1/2fm b. Ts is lesser than 1/2fm c. Ts is greater than 1/2fm d. Ts is lesser than or equal to 1/2fm

These multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final answer. 9) According to sampling theorem a. Ts is equal to 1/2fm b. Ts is lesser than 1/2fm c. Ts is greater than 1/2fm d. Ts is lesser than or equal to 1/2fm

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter17: Commercial And Industrial Air-conditioning Control Systems

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Related questions

Q: For the following Signal: To1 Toz ◆ Sec. To The ratio between To1 and To2 is Sec. ◆ Sec. x(n) = cos²…

Q: Q2: Fill in the blanks for the following 1- The main steps of communication system are 2- The…

Q: 2) Frequency response of an LTI system is given as: H(e jo) = (1- 0.5 e to)/(1-2 e jo ). a) Find the…

Q: Select the correct answer 5. In a digital communication system, regarding the effect on the…

A: Option D is the correct one as we cannot accurately determine which signals have been transmitted by…

Q: 1) A discrete-time, causal and LTI system is shown below. x[n] and y[n] are input and output signals…

A: Here impulse response is asked to find out where the input and output response are given Here…

Q: The task of the modulator is: O a. Amplification of the analogue signal before transmission. O b.…

A: Modulator: A modulator is an electronic circuit that combines two signals with one is of low…

Q: a) Why the energy band gap is also known as forbidden band gap? Sketch the energy band diagrams and…

A: According to the question, we need to discuss energy band gap. Also need to discuss the width of the…

Q: Consider a 6-bit ADC and full scale voltage measurement range of (0-59).The Resolution will be…

A: Given that : 6 bit ADC range (0-59) to Find Resolution :

Q: Probability density function defines a. Density of signal b. Amplitudes of random noise c.…

A: Pdf is whose value at any given sample in the sample space can be interpreted as providing a…

Q: 1. Explain in your opinion the operation of a forward bias using the following: a. Depletion Region…

A: Forward bias: In general forward bias is defined as follows. when a P-type semiconductor and N-type…

Q: Q4/ Why the performance of multimode graded index is better than multimode step index? Q5/ Design…

A: According to guidelines solving only one question at a time4) To discussWhy the performance of…

Q: Identify the incorrect sentence from the following. O a. FET is a passive component. b. BJT is a…

A: Incorrect sentence is A) FET is a passive component and all the given sentences are correct b) BJT…

Q: One of the following is not a type of sampling

A: - Sampling is the process of the reduction of a continuous time signal to a discrete time signal.

Q: 1. With the help of Octave program perform the Modulation and Demodulation (AM) of information…

A: According to the question, We need to perform modulation and demodulation by using the Octave…

Q: 2.15. A signal in the frequency range 300 to 3300 Hz is limited to a peak-to-peak swing of 10 V. It…

A: Given data is- Vp-p=10 voltf=300-3300 Hzsamples C=8000 sample/sSpaced level M=64

Q: Sampling Process 3.1 A narrowband signal has a bandwidth of 10 kHz centered on a carrier frequency…

A: According to the sampling theorem, if the bandwidth of a narrowband is represented by 2ω, so, the…

Q: Implement 8-bit asynchronous ripple counter and showing truth table, timing diagram. Also show how…

A: According to the question, we need to implement an 8-bit asynchronous ripple counter and showing the…

Q: In the context of digital communication, please explain Communication Channel and Noise in detail.

A: Given we need to enumerate communication channel and noise in detail. Please find the below…

Q: 1) Compare between PCM and DM regarding the sampling frequency. 2) A linear delta modulator is…

Q: [0 5] the signal in the volt range will be quantified. since n=4; a)Calculate what is the number of…

A: We need to calculate number of level , and step size for quantization .

Q: We want to design a digital circuit that converts Gray code (ABC) to Binary code (xyz). Set up a…

A: See belowExplanation:

Q: Question No 1. A) Describe encoding technique (Digital Data to Digital Signal) and explain about…

A: A) Encoding technique: Encoding is the way of converting the data into specified format and all…

Q: Quantization noise can be reduced when the size of quantization level is decreased. a. False b. True

Q: A waveform x (t) = 10 cos (1000t+n/3) 20cos (2000t+ a/6) is to be aniformly sampled for digital…

A: Given, x(t)=10 cos (1000t+π/3)20cos(2000+π/6) Maximum frequency =20002π=1000π Hz Minimum sampling…

Q: 12)If the sampling frequency is 1 KHz, then the number of samples in 5 minutes is equal to…

A: The solution can be achieved as follows.

Q: Arrange the chronological order of the elements and its function to Digital Communication by writing…

A: Digital communication is the process of sending digital data to various locations, when analog data…

Q: In Digital Modulation, a. the information is an analog and carrier is a digital signal b. both the…

A: The answer as given below:

Q: orescribed action accordingly. A) Regulating trade, B) monitoring functions. C) measure physical…

A: 1. option b is correct answer. because monitoring function tells about the activities and analysis…

Q: 7- When does over-modulation occur? a) Modulating signal voltage carrier voltage c) Modulating…

A: Over-modulation Over-modulation is a situation in which the modulating signal voltage is much…

Q: Q1- Draw a grey code 8 QAM constellation Diagram...

A: Gray coding is a method which is used by multilevel modulation schemes. These are often used to…

Q: Choose the correct answer low HDOP (Horizontal Dilution of Precision) number such as 2 indicates a…

A: In this we have to find low HDOP (Horizontal Dilution of Precision) number such as2 indicates ...

Question

100%

These multiple choice question from DIGITAL COMMUNICATIONS course.
just write for me the final answer.

According to sampling theorem

Ts is equal to 1/2fm

Ts is lesser than 1/2fm

Ts is greater than 1/2fm

Ts is lesser than or equal to 1/2fm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Select the correct answer5. In a digital communication system, regarding the effect on the probability of error, it is not relevant to seek ..A. one channel without distortion.B. a good SNR.C. a channel without noise.D. high fidelity of the signals.
Implement 8-bit asynchronous ripple counter and showing truth table, timing diagram. Also show how it can be used as frequency divider?
Q1- Draw a grey code 8 QAM constellation Diagram...This question is of electrical engineering from the course analogue to digital converting and the topic is Digital modulation(Quadrature Amplitude Modulation QAM).. Kindly solve it asap
To implement 8-to-1 line multiplexer using two 4-to-1 line multiplexer(MUX): O a. The third selctor is connected to the enable line of the first and second MUX. O b. Only the enable line of the first MUX must be connected dirictly to the enable for the second MUX. O c. The third selctor is connected to the enable line of the first MUX which is connected through inverter to the enable of the second MUX. O d. All inputs lines for the first mux must be connected to the input lines for the second mux.
Choose the correct answer low HDOP (Horizontal Dilution of Precision) number such as2 indicates a ........................... a.poor fix b.good fix c.poor signal quality d. good signal quality
Data communication subject , i need now fast less than 5 m
what is Successive approximation ADC? please explain
6) This QUESTION FROM Information theory course. just write for me the the correct answer.
Subject: Engineering Electronics In 150 words or more: Kindly answer the question in essay form. Why does base bias produce such an unstable Q point?
In Digital Modulation, a. the information is an analog and carrier is a digital signal b. both the information and carrier are analog signal c. both the information and carrier are digital signal d. the information is a digital and carrier is an analog signal.
Sketch each of the following special digital sequences: a. 58 (n) b. -28 (n-5) c. -5u(n) d. 5u(n-2)
Write TRUE if the statement is correct but if it’s false, change the underlined word or groupof words to make the whole statement correct. The subject is basic electronics. please answer my questions. thanks