A 60 µF capacitor that had been charged to 30 V is discharged through a resistor. The figure (Figure 1)shows the capacitor voltage as a function of time. Part A What is the value of the resistance? Figure 1 of 1 Express your answer using two significant figures. ΑΣφ ? AVc (V) R = 30 20 10 t (ms) 4 6.

A 60 µF capacitor that had been charged to 30 V is discharged through a resistor. The figure (Figure 1)shows the capacitor voltage as a function of time. Part A What is the value of the resistance? Figure 1 of 1 Express your answer using two significant figures. ΑΣφ ? AVc (V) R = 30 20 10 t (ms) 4 6.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 18-cm-long nichrome wire is connected across the terminals of a 1.5 V battery. ▼ J= 5.6×106 A m² Submit Previous Answers ✓ Correct Correct answer is shown. Your answer 5.58.10⁰ was either rounded differently or used a different number of significant figures than required for this part. Part C If the current in the wire is 3.0 A, what is the wire's diameter? Express your answer with the appropriate units. μÅ xa Xb d= 0.8 10 Submit -4 . x 10m m X Previous Answers Request Answer ? X Incorrect; Try Again; 7 attempts remaining
Part A In an integrated circuit, the current density in a 2.0-um-thick x 71-µm-wide gold film is 7.3x105 A/m? How much charge flows through the film in 15 min? Express your answer to two significant figures and include the appropriate units. HA ? Q = Value Units Submit Request Answer Provide Feedback
Part A Given the following electric circuit R1 ???0 Amperemeter V Voltmeter The voltmeters shows 5 Volt ВAT1 R2 10 0 R3 10 Q 9 V It is known that the voltage measured by the voltmeter is 5 Volt 3. Calculate the Power provided por the battery to the system
Consider the circuit in (Figure 1). Suppose that v₁ = 14 V, v2 = 5 V, and i = 5 mA. Figure i + 1 of 1 5 mA source is absorbing power. 5 V and 14 V sources are developing power. 5 V and 14 V sources are absorbing power. 5 mA source is developing power. All sources are absorbing power. O All sources are developing power. Submit Correct Part G Previous Answers What is the total power developed in the circuit if the polarity of the 14 V source is reversed? Express your answer to three significant figures and include the appropriate units. P= 25 Submit mW Previous Answers Request Answer ? X Incorrect; Try Again; 3 attempts remaining
A waterbed heater uses 440 W of power. It is on 35% of the time, off 65 %. Part A What is the annual cost of electricity at a billing rate of $0.12 per kWhr? Express your answer in dollars. B VEL ΑΣΦ ? cost= dollars Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining t
A capacitor is charged to a potential of 12.0 V and is then connected to a voltmeter having an internal resistance of 3.80 MS. After a time of 3.00 s, the voltmeter reads 3.0 V. Part A What is the capacitance of the circuit? Express your answer with the appropriate units. C = Submit Part B T = Value Request Answer Submit What is the time constant of the circuit? Express your answer with the appropriate units. Value Units Request Answer PO Units ? ?
A potential difference of 81 mV exists between the inner and outer surfaces of a cell membrane. The inner surface is negative relative to the outer surface. How much work is required to eject a positive sodium ion (Na+) from the interior of the cell?_______________________J
Part A What is the equivalent resistance of group (a) of resistors shown in the figure? (Figure 1) Express your answer in ohms to two significant figures. Req= ΤΟ ΑΣΦ Submit Request Answer Part B ? Ω What is the equivalent resistance of group (b) of resistors shown in the figure? Express your answer in ohms. Η ΑΣΦ Req = Submit Request Answer Part C ? Ω What is the equivalent resistance of group (c) of resistors shown in the figure? Express your answer in ohms. Req= -Ο ΑΣΦ Submit Request Answer Provide Feedback ? Ω Consta
A student wanted to make a 701 Watt toaster for his physics professor. If the toaster will be plugged into a 120 volt electrical outlet, what should be the resistance in ohms of the heater wire to give the desired wattage? (Enter answer as a number with 1 digit to the right of the decimal. Do not enter unit.) A Moving to another c
A 90 M2 resistor has a current of 0.68 A and is connected in series with a 110 resistor. Part A What is the emf of the battery to which the resistors are connected? Express your answer using two significant figures. IVE ΑΣΦ ε = ? kV
A resistor with resistance R is connected to a battery that has emf 13.0 V and internal resistance r = 0.39 N. Part A For what two values of R will the power dissipated in the resistor be 78.0 W? Express your answers in ohms. Enter your answers separated by a comma. ? R1, R2 = Ω Submit Request Answer
A resistor with resistance R is connected to a battery that has emf 14.0 V and internal resistance r = 0.37 N. Part A For what two values of R will the power dissipated in the resistor be 76.0 W? Express your answers in ohms. Enter your answers separated by a comma. ? R1, R2 = Submit Request Answer