A 3300Volts, 60 Hz, 2 phase network is connected to a 3 phase, 4 wire system by a Scottconnected transformer combination. If there are 1200 turns on the 2 phase side, calculate the number of turns on the3 phase side required for the main and teaser transformers. Voltage per phase on the 3 phase side is 220 V.

A 3300Volts, 60 Hz, 2 phase network is connected to a 3 phase, 4 wire system by a Scottconnected transformer combination. If there are 1200 turns on the 2 phase side, calculate the number of turns on the3 phase side required for the main and teaser transformers. Voltage per phase on the 3 phase side is 220 V.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 10R

See similar textbooks

Similar questions

A 24A, 240V single-phase load having a length of 100 ft is located 100 ft from a panel board and is wired with two 10 AWG conductors. What's the approximate voltage drop of the branch-circuit conductors? (a) 4.25V (b)5.97V (c)3% (d)5% Please answer in typing format please ASAP for
7. What arrester nominal rating shall be used in a 13.8 KV grounded system? How and why? • 11 KV• 18 KV• 15 KV• 21 KV
3- What was the effect of neutral wire removal in three phase circuit balanced ?
draw and explain service connection wiring diagram for 1 phase and 3 phase installation
MSQ
The desired secondary voltage is 115 volts l, 3-phase, to monitor the voltage of 230 kV line and PT's are to be installed. The PT's are to connected delta-wye. What shall be the PT's voltage ratio?
all elements in a circuit that carry the same current are said to be ______ a. closed-loop b. network c. series d. bilateral
What was the effect of neutral wire removal in balanced and unbalanced 3-phase circuit?
In an overhead system, the basis of comparison is the maximum voltage between conductor and ground. Why ?
Question 7 A 30 Ohm resistor is in series with a 80 Ohm Inductive reactance. If they are connected to a 25 Volt a.c. source, what is the magnitude of the phase shift between the supply current and voltage (in Degrees)? **Only give the magnitude. If you believe the current is lagging OR leading, give a positive value for the angle
a. What is the ampere rating of circuit A16? _________________ b. What is the conductor size of circuit A16? _________________
Calculate element and welding currents with mesh analysis.