Answered: A 3.00 kg sample of water is heated…

A 3.00 kg sample of water is heated from 14 degrees celsius to 53 degrees celsius. How much energy is absorbed by the water?

World of Chemistry

7th Edition

ISBN:9780618562763

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter10: Energy

Section: Chapter Questions

Problem 48A

See similar textbooks

Similar questions

A 45-g aluminum spoon (specific heat 0.88 J/g C) at 24 C is placed in 180 mL (180 g) of coffee at 85 C and the temperature of the two become equal. (a) What is the final temperature when the two become equal? Assume that coffee has the same specific heat as water. (b) The first time a student solved this problem she got an answer of 88 C. Explain why this is clearly an incorrect answer.
A book is held 6 feet above the floor and then dropped. Which statement is true? a.The potential energy of the book is converted to kinetic energy. b.The potential energy of the book is destroyed. c.Kinetic energy is created. d.The total energy of the system will not be conserved.
During a recent winter month in Sheboygan, Wisconsin, it was necessary to obtain 3500 kWh of heat provided by a natural gas furnace with 89% efficiency to keep a small house warm (the efficiency of a gas furnace is the percent of the heat produced by combustion that is transferred into the house). (a) Assume that natural gas is pure methane and determine the volume of natural gas in cubic feet that was required to heat the house. The average temperature of the natural gas was 56 F; at this temperature and a pressure of 1 atm, natural gas has a density of 0.68 1 g/L. (b) How many gallons of LPG (liquefied petroleum gas) would be required to replace the natural gas used? Assume the LPG is liquid propane [ C3H8 : density, 0.5318 g/mL; enthalpy of combustion, 2219 Id/mo for the formation of CO2(g) and H2O(l) ] and the furnace used to burn the LPG has the same efficiency as the gas furnace. (c) What mass of carbon dioxide is produced by combustion of the methane used to heat the house? (d) What mass of water is produced by combustion of the methane used to heat the house? (e) What volume of air is required to provide the oxygen for the combustion of the methane used to heat the house? Air contains 23% oxygen by mass. The average density of air during the month was 1.22 g/L. (f) How many kilowatt—hours ( 1kWh=3.6106 J) of electricity would be required to provide the heat necessary to heat the house? Note electricity is 100% efficient in producing heat inside a house. (g) Although electricity is 100% efficient in producing heat inside a house, production and distribution of electricity is not 100% efficient. The efficiency of production and distribution of electricity produced in a coal-fired power plant is about 40%. A certain type of coal provides 2.26 kWh per pound upon combustion. What mass of this coal in kilograms will be required to produce the electrical energy necessary to heat the house if the efficiency of generation and distribution is 40%?
If 100. J of heat energy is applied to a 25-g sample of mercury, by how many degrees will the temperature of the sample of mercury increase? (See Table 10.1.)
How much heat is required to raise the temperature of 100. grams of water from 25C near room temperature to 100.C its boiling point? The specific heat of water is approximately 4.2Jperg-K. a.3.2104J b.32J c.4.2104J d.76J
Explain the economic importance of conversions between different forms of energy and the inevitability of losses in this process.
1-86 The specific heats of some elements at 25oC are as follows: aluminum = 0.215 cal/g · oC; carbon (graphite) = 0.170 caI/g oC; iron = 0.107 cal/g mercury = 0.033 1 caI/g oC. (a) Which element would require the smallest amount of heat to raise the temperature of 100 g of the element by 10oC? (b) If the same amount of heat needed to raise the temperature of 1 g of aluminum by 25oC were applied to 1 g of mercury, by how many degrees would its temperature be raised? (c) If a certain amount of heat is used to raise the temperature of 1.6 g of iron by 10oC, the temperature of 1 g of which element would also be raised by 10oC, using the same amount of heat?
9.90 Many engineering designs must incorporate ways to dissipate energy in the form of heat. Water evaporators are common for this task. (a) What property of water makes it a good material for evaporators? {b} If an application could not use water, hut instead was forced to use a material with a value for the property in part (a) that was one half that of water, what changes would need to be made in the design?
Classify each process as exothermic or endothermic. (a) ice melts (b) gasoline burns (c) steam condenses (d) reactants products, H = 50 kJ
friend of yours reads that the process of water freezing is exothermic. This friend tells you that this can’t be true because exothermic implies “hot,” and ice is cold. Is the process of water freezing exothermic? If so, explain this process so your friend can understand it. If not, explain why not.
Which of the following has the highest thermal energy? (a) 1.0 g of ice at 0 (b) 1.0 g of liquid water at 25 C (c) 1.0 g of liquid water at 100 C (d) 1.0 g of water vapor at 100 C
Which of the following is an endothermic process? combustion of gasoline in a car engine i>sublimation of carbon dioxide: water condensing on a cold pipe freezing juice to make popsicles