A 3-kg shaft CA passes through a smooth journal bearing at B. Springs are attached the bearing at B and the caps at C and A. Initially, the springs are unstretched when no force is applied to the shaft. In this position, s = s' = 250 mm and the shaft is at rest. If a horizontal force of F = 5 kN is applied, determine the speed of the shaft the instant whens = 100 mm and s'= 400 mm. %3!

A 3-kg shaft CA passes through a smooth journal bearing at B. Springs are attached the bearing at B and the caps at C and A. Initially, the springs are unstretched when no force is applied to the shaft. In this position, s = s' = 250 mm and the shaft is at rest. If a horizontal force of F = 5 kN is applied, determine the speed of the shaft the instant whens = 100 mm and s'= 400 mm. %3!

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The pendulum illustrated in the figure is composed of an AB 2 kg and a 5 kg disc. The pendulum is released from rest in the shown position and falls 0.3 m without undergoing any rotation until the end A reaches the hook S, which starts to provide a permanent connection. Determine the angular velocity of the pendulum after turning 90 °. Treat the weight of the pendulum during impact as a non-impulsive force.
None
Please show full work for thumb up.
The 0.6-lb particle is guided along the circular path using the slotted arm guide. Motion occurs in the horizontal plane with negligible friction. Note that the circular part of the slot has the radius equal to 0.5 ft, and the radial position, r, is measured from the hinge and the angle is measured in the counter-clockwise direction. If the arm has an angular velocity = 4 rad/sec and an angular acceleration 6 - 8 rad/sec² at the instant when 0 = 30°, determine the force of the arm guide on the particle at the instant. Present your answer in lb using 3 significant figures. 0.5 ft 0 0.5 ft.
4-The 20-g bullet is fired horizontally at 1400 m/s into the 350-g block resting on a smooth surface. If the bullet becomes embedded in the block, what is the velocity of the block immediately after impact
The spring of constant k is unstretched when the slider of mass m passes position B. If the slider is released from rest in position A, determine its speed as it passes points B and C. What is the normal force exerted by guide on the slider at position C? d tion B Slider TAT 18* & quide
The spring-mounted 0.89-kg collar A oscillates along the horizontal rod, which is rotating at the constant angular rate θ˙=8.2θ˙=8.2 rad/s. At a certain instant, r is increasing at the rate of 700 mm/s. If the coefficient of kinetic friction between the collar and the rod is 0.63, calculate the friction force F exerted by the rod on the collar at this instant.
At the instant shown, link CD rotates with an angular velocity of W = 9.0 rad/s. If it is subjected to a couple moment M= 320 N-m, determine the magnitude of the vertical reaction force developed on pin D. The block has a mass of 50 kg and center of mass at G. Neglect the mass of links AB and CD. (Hint, since the mass of link AB or CD is negligible, the external force or moment acting on it sums up to 0.) Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point, and proper unit. Take g = 9.81 m/s². 0.1 m 0.6 m В А 0.4 m' G 0.4 m D C M Your Answer: Answer units
The pavement compactor is traveling down the incline at VG = 5 ft/s when the motor is disengaged. The body of the compactor, excluding the rollers, has a weight of 8000 lb and a center of gravity at G. Each of the two rear rollers weighs 400 lb and has a radius of gyration of KA = 3.3 ft. The front roller has a weight of 800 lb and a radius of gyration of kg = 1.8 ft. The rollers do not slip as they rotate. (Figure 1) Figure 3.8 ft 5 ft A GT 10 ft 1 of 1 30 730 ▼ Part A Determine the angular velocity of the roller B when the compactor has traveled 16 ft down the plane. Express your answer in radians per second to three significant figures. WB = Submit IVE ΑΣΦ | Η Provide Feedback Request Answer P Pearson vec ? rad/s Next >
The frame of a tandem drum roller has a weight of 5000 N excluding the two rollers. Each roller has a weight of 1900 N and a radius of gyration about its axle of 1.25 m.If a torque of M = 300 N.m is supplied to the rear roller A ,determine the speed of the drum roller 20 s later, starting from rest. 1.5m 1.5 m B M = 300 N.m
The system consists of a 19-lb disk A, a 4-lb slender rod BC, and a 3-lb smooth collar C. If the disk rolls without slipping, determine the velocity of the collar at the instant θ = 20°. The system is released from rest when θ = 48°.