A 2kg/s of steam expands in a turbine producing 560 kW of power output. The steam enters at a velocity of 20 m/s and exits at 75 m/s. The reduction of specific enthalpy is 410KJ/kg. Determine that the heat flow per second when the inlet of the turbine is located 950mm above the outlet.

A 2kg/s of steam expands in a turbine producing 560 kW of power output. The steam enters at a velocity of 20 m/s and exits at 75 m/s. The reduction of specific enthalpy is 410KJ/kg. Determine that the heat flow per second when the inlet of the turbine is located 950mm above the outlet.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Air enters a gas turbine steadily at pressure 20 kPa, volumetric flowrate 1,000 m3/s, and temperature 300 oC. If the air exits the turbine at pressure 7 kPa and temperature 80 oC, determine the power generation in the turbine assuming changes in the kinetic energy and potential energy at the inlet and outlet condition is negligible. Determine the volumetric flowrate of air out of the turbine.
I need the answer as soon as possible
Steam enter a turbine stage with an enthalphy of 3628 kJ/kg at 70m/s and leaves the same stage with an enthalpy of 2846kJ/kg and a velocity of 124 m/s. Calculate the work done by the steam.
A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. Water enters this pump at 41.51°C through a 1.774-cm-diameter opening and exits through a 2.327-cm-diameter opening. Determine the velocity of the water at the outlet in m/s when the mass flow rate through the pump is 1.163 kg/s. The specific volume of incoming water is 1.303 x 10³ m³/kg.
. Steam at an initial enthalpy of 100 kJ/kg and inlet velocity of 100 m/s, enters an insulated horizontal nozzle. It leaves the nozzle at 200 m/s. Determine the exist enthalpy (in kJ/kg).
A 5 KW pump is used to raise the elevation of a lake's water by 25 m from the free surface of the lake. The pipe inlet is 2 m below the free surface. The temperature of water increases by 0.05oC during the process as a result of the frictional effects. Neglecting any heat transfer and kinetic energy changes, determine the mass flow rate of the water.
Determine the moment of the 225-Ib force about point A and about point O.
A man purchases a turbine for use in his factory. He sets it up so that there is steam entering at 5000 kpa and at 873.15 Kelvin at a constant rate of 100 m/sec. This steam seems to leave the turbine at 100 m/sec and of 95% quality at a pressure of 0.01MPa. The manufacturer sticker claims the turbine has a power output known to be 56400 Joules per second. Find the theoretical mass flowrate of the steam through the device [kg/sec] and the area of the outlet [m^2]
A pump increases the water presssure from 8kPa at the inlet to 700 kPa at the outlet. Water enters this pump at 41.51 degrees celsius through a 1.145-cm-diameter opening and exits through a 2.821-cm-diameter opening. Determine the velocity of the water at the outlet in m/s when the mass flow rate through the pump is 1.354kg/s. The specific volume of incoming water is 1.547x10-3m3/kg.
An adiabatic steam turbine receives steam from two boilers. One flow has a mass flow rate (rim) of 5.7 kg/s at 3 MPa and 600 °C. The other flow has a mass flow rate (m) of 6.0 kg/s at 0.5 MPa and 600 °C. The exit flow is at 10 kPa with a quality of 100%. Neglect ΔΚΕ (Higure 1) Part A Determine the total power output. Express your answer to three significant figures. Vα ΑΣΦ vec ? MW Submit Request Answer Part B Provide Feedback Figure West
Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in which the pressure is reduced and electricity is produced. The shaft power input to the pump is 1 KW snd the shaft power output the turbine is 1 kW. Both the pump and turbine are 90% efficient. If the elevation and velocity of the water remain constant through out the flow and irreversible headloss is 1 m, the pressure of water in kPa at the turbine exit is A. 131 B. 129 C. 126 D. 127 With F.B.D