A 222 mm-diameter bolt having a diameter at the root of the threads of 18.6 mm is used to fasten two timbers as shoun in the figure below. The nut is tightened to cause a tensile load in the bolt of 34 kN. mm Determine the following: a. Shearing Stress in the head bolt. b. Shearing in the thread c. The outside diameter of the washers if their inside diameter is 28 mm and the 16 mm mm bearing stress is limited to 6 MPa.

Q: The round shaft shown below is subjected to an axial impact/shock direct tensile load of F = 50000…

A: It is given that the stress at groove and the hollow part is equal, thus we will first look at the…

Q: Calculate the bearing stress and shear stress between the pin and each bracket of a clevis joint.…

A:

Q: 4. Solve problem 8.10 in our textbook (find the safety factor for failure at the fillet). Note that…

A:

Q: Problem 4-1. For the following shaft determine the support reactions, and maximum shear stress in AB…

A: The torque is The modulus of rigidity are

Q: A steel bolt 25 mm in diameter carries a load of 4 kN in tension. Estimate the tensile stress of the…

A: Given data Load= 4 kn Diameter of bolt = 25 mm Diameter of thread = 20 mm Find the tensile stress at…

Q: 600 N Problem 5: Fatigue A bicycle crank experiences cyclic loading due to the force applied by the…

A:

Q: A course pitch metric grade 9.8 bolt with a hexagonal nut assembly is used to keep two machined…

A: Step 1: Step 2: Step 3: Step 4:

Q: Axial loads are applied with rigid bearing plates to the solid cylindrical rods shown in the figure.…

A:

Q: 10) A screw clamp similar to the one shown in the figure has a handle with diameter in made of…

A: Given Screw clamp To find Torque it can handle

Q: B -1.5 m Figure 2 The -red-brass rod AB of 1.5 m and the aluminium rod BC of 1 m, shown in Figure 1,…

A:

Q: 1) Ball bearings support the rotating axle shown below at points A and D. The rotating axle is…

A: Treat the shaft as simply supported beam with supports at A and D.Here  are reaction forces at…

Q: Calculate the maximum tensile stress developed in a 1/4-20 bolt (Major dia = 0.2500" and Root dia =…

A: Write the given data with suitable variables: P=426 lbdmin=0.1959 in

Q: Axial loads are applied with rigid bearing plates to the solid cylindrical rods shown. The normal…

A: Given data: P=9 kipsQ=4 kipsR=18 kipsS=21 kipsσ1=19 ksiσ2=24 ksiσ3=12 ksi Need to determine the…

Q: Suppose the load in the figure below is 2 kN. Further suppose that the distance between the load and…

A: Given : P= 2kN The distance between load and centroid is 1.3 m The horizontal distance between bolt…

Q: 2. Calculate the shear stress in a simple pin joint, assuming pin diameter of 10 mm and 3550N…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.