A 2.220 kg block of wood rests on a steel desk. The coefficient of static friction between the block and the desk is u, = 0.605 and the coefficient of kinetic friction is u = 0.255. At time t = 0, a force F = 8.10 N is m µs,k applied horizontally to the block. State the force of friction applied to the block by the table at times t = 0 and t > 0. t = 0 N t > 0 N Consider the same situation, but this time the external force F is 16.3 N. Again, state the force of friction acting on the block at times t = 0 and t > 0. t = 0 N t > 0 N とTOOLS x10

A 2.220 kg block of wood rests on a steel desk. The coefficient of static friction between the block and the desk is u, = 0.605 and the coefficient of kinetic friction is u = 0.255. At time t = 0, a force F = 8.10 N is m µs,k applied horizontally to the block. State the force of friction applied to the block by the table at times t = 0 and t > 0. t = 0 N t > 0 N Consider the same situation, but this time the external force F is 16.3 N. Again, state the force of friction acting on the block at times t = 0 and t > 0. t = 0 N t > 0 N とTOOLS x10

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A small box of mass 4.1kg is sitting on a board of mass 1kg and length 1.1m(Figure 1). The board rests on a frictionless horizontal surface. The coefficient of static friction between the board and the box is 0.54. The coefficient of kinetic friction between the board and the box is, as usual, less than 0.54. Throughout the problem, use 9.8m/s^2 for the magnitude of the acceleration due to gravity. In the hints, use Fr for the magnitude of the friction force between the board and the box. Figure esc ! 1 FI m₂ L 2 F2 #3 1 of 1 > 80 F3 E $ 4 888 F4 Part A R Find Fmin, the constant force with the least magnitude that must be applied to the board in order to pull the board out from under the the box (which will then fall off of the opposite end of the board). View Available Hint(s) Fmin = Submit Provide Feedback % [5] ΑΣΦ 5 F5 T 1 MacBook Air 6 F6 Y & 7 www. F7 ? U N 8 00 DII FB 1 ( 9 DD F9 I ) C F10 I 1 P (1 Review I Constants F11 I + Next > F12
A 315 kg block on a frictionless surface was pulled by a horizontal force with magnitude 230 N to make it move along the horizontal surface. Find the normal force.
A 5.740 kg block of wood rests on a steel desk. The coefficient of static friction between the block and the desk is u, = 0.555 and the coefficient of kinetic friction is µy = 0.305. At time t = 0, a force F = 19.2 N is applied F horizontally to the block. State the force of friction applied to the block by Us,k the table at times t = 0 and t > 0. t = 0 t > 0 N Consider the same situation, but this time the external force F is 38.8 N. Again, state the force of friction acting on the block at times t = 0 and t > 0. %3D t = 0 t > 0 N
A block of mass 5.60 kg is pushed up against a wall by a force P that makes an angle of 0 = 50.0° angle with the horizontal as shown below. The coefficient of static friction between the block and the wall is 0.280. (a) Determine the possible values for the magnitude of P that allow the block to remain stationary. (If there is no maximum, enter NONE in that answer blank.) |Pmax! N |Pmin = (b) What happens if |P| has a larger value than |P, O The block slides up the wall. max/? O The block does not slide along the wall. O The block slides down the wall. What happens if |PI has a smaller value than |Pminl? The block slides up the wall. O The block does not slide along the wall. O The block slides down the wall. (c) Repeat parts (a) and (b) assuming the force makes an angle of 0 = 12.4° with the horizontal. Determine the possible values for the magnitude of P that allow the block to remain stationary. (If there is no maximum, enter NONE in that answer blank.) IP max N |Pminl = N What…
A block of mass 5.40 kg is pushed up against a wall by a force P that makes an angle of = 50.0° angle with the horizontal as shown below. The coefficient of static friction between the block and the wall is 0.300. (a) Determine the possible values for the magnitude of P that allow the block to remain stationary. (If there is no maximum, enter NONE in that answer blank.) P. maxl= IP A N X Your response differs from the correct answer by more than 10%. Double check your calculations. N P Pminh, = 92.32 (b) What happens if IP has a larger value than IP The block slides up the wall. The block does not slide along the wall. The block slides down the wall. |Pmaxl = P min! = What happens if IP has a smaller value than IP min!? The block slides up the wall. O The block does not slide along the wall. The block slides down the wall. (c) Repeat parts (a) and (b) assuming the force makes an angle of = 12.0° with the horizontal. Determine the possible values for the magnitude of P that allow the…
At an accident scene on a level road, investigators measure a car's skid mark to be 88 m long. It was a rainy day and the coefficient of friction was estimated to be 0.35. a.)Use these data to determine the speed of the car when the driver slammed on (and locked) the brakes. Express your answer to two significant figures and include the appropriate units.
If rope BC will fail when the tension becomes 45 kN, determine the greatest vertical load Fthat can be applied to the beam at B. What is the magnitude of the reaction at A for this loading? Neglect the thickness of the beam. 26 kN F C 13 12 B 2 m 4 m
Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and direction of the third force so that the resultant of the three forces is vertically downward with a magnitude of 1160 lb. 1010 lb 45° 35° 430 lb
Two ropes are attached to a tire on the ground. The first rope exerts a force of 205. N in a direction 14.9 degrees west of north. The second rope exerts a force of 362. N in a direction 27.6 degrees east of south. Find the magnitude (in N) of the net force on the tire
Determine whether the block shown is in equilibrium and find the magnitude and direction of the friction force when = 35° and P= 103 lb. Given: μs = 0.3 and μk = 0.2. 250 lb The block is in equilibrium. (Click to select) ✓ The magnitude and direction of the friction force is lb (Click to select)
A contestant in a winter sporting event pushes an mm kg block of ice across a frozen lake by applying a force FF at an angle θθ below the horizontal as shown. Assume that the coefficient of static friction for ice on ice is 0.0300, and the coefficient of kinetic friction for the same is 0.0100. Let to the right be the positive x direction and up be the positive y direction for your equations. Obtain a numeric value, in newtons, for the magnitude of the maximum applied force, F, consistent with static friction when the force makes an angle 32° below the horizontal and the mass of the block is 63 kg. Obtain a numeric value for the acceleration, a, in meters per squared seconds, when the mass of the block is 63 kg and the angle of the rope is 32° below the horizontal.
10. a. In investigating an acccident, police find skid marks left by a car as the driver slammed on the brakes and the car skidded to a halt. The skid marks form a straight line 3.9375 m long on a flat road. It was raining and the coefficient of friction was 0.32125. The mass of the car is 1486.75 kg. What is the angle between the friction force and the displacment of the car? Previous submissions: b. Using W = F Ax cos 0, what was the work done by friction? Previous submissions: c. What was the AKE? Previous submissions: d. What was the initial velocity of the car? Take this to be positive.