A 2 inch-diameter horizontal jet of water with a velocity of 20 ft/s relative to the ground strikes a flat plate that is attached to a car moving at a velocity of \( V_c \). After it hits, the water splatters in all directions in the plane of the plate. Investigate the effect of the car velocity \( V_c \) on the force exerted on the plate. The image illustrates the concept of propulsion using a water jet. It shows a nozzle expelling a stream of water, labeled "Water jet," directed towards a cart. The cart is depicted on wheels, allowing it to move forward in response to the force exerted by the water. An arrow labeled \( V_c \) indicates the velocity of the cart in the forward direction, opposite to the water jet's trajectory.Key components:- **Nozzle**: The device through which water is expelled.- **Water jet**: The stream of water causing a reactionary force that propels the cart forward.- **Cart**: The structure in motion, mounted on wheels, demonstrating the action-reaction principle.- **Velocity Arrow (\( V_c \))**: Shows the direction and relative velocity of the cart as it moves.This diagram exemplifies fundamental principles of physics, specifically Newton's Third Law of Motion: for every action, there is an equal and opposite reaction.

Given velocity of jet of water, Vj=20 (ft/s) and the diameter of water jet, d=2 in =212 ft=0.167 ft…

A 2 inch-diameter horizontal jet of water with a velocity of 20 ft/s relative to the ground strikes a flat plate that is attached to a car moving at a velocity of Ve. After it hits, the water splatters in all directions in the plane of the plate. Investigate the effect of the car velocity Ve on the force exerted on the plate.

A 2 inch-diameter horizontal jet of water with a velocity of 20 ft/s relative to the ground strikes a flat plate that is attached to a car moving at a velocity of Ve. After it hits, the water splatters in all directions in the plane of the plate. Investigate the effect of the car velocity Ve on the force exerted on the plate.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Sand is discharged from the silo at A at a rate of 46 kg/s with a vertical velocity of 10 m/s onto the conveyor belt, which is moving with a constant velocity of 1.5 m/s. The conveyor system and the sand on it have a total mass of 810 kg and center of mass at point G. Neglect the thickness of the conveyor.(Figure 1) 1)Determine the vertical component of reaction at the roller support A 2)Determine the horizontal component of reaction at the pin support B 3)Determine the vertical component of reaction at the pin support B
A roofer tosses a small tool to the ground. What minimum magnitude vo of horizontal velocity is required to just miss the roof corner B? Also determine the distance d. Answers: Vo = d = i i -2.8 m- pod pop 1/0 LAALAAL 1.3 m + 0.9 m m 4.1 m m/s
A rocket lifts off from Earth initially at a mass of 50,000 kg. If it burns 40,000 kg of fuel during 40 seconds, it increases its speed by 5 km/s. 1. What is the exhaust velocity of the rocket? 2. What is the mass loss rate of the rocket? 3. What is the thrust of the rocket?
Please write legibly.
Ballast Dropped from a Balloon A ballast is dropped from a stationary hot-air balloon that is hovering at an altitude of 520 ft. The velocity of the ballast after t sec is -32t ft/sec. Ballast (a) Find the height h(t) (in feet) of the ballast from the ground at time t. Hint: h'(t) = -32t and h(0) = 520. h(t) = -162. + 520 (b) When will the ballast strike the ground? (Round your answer to two decimal places.) 16.25 X sec (c) Find the velocity of the ballast when it hits the ground. (Round your answer to two decimal places.) ft/sec
One part of an inspection system in a packaging operation uses an air blast to remove defective pieces of cardboard from the conveyor belt. The blast is initiated by a sensor and clocked so that the product is in front of the blast at just the right . The product is going to be dumped onto a shelf next to the conveyor belt. Determine the speed of the air jet required to tip the cardboard off the conveyor. The density of air is 1.10 kg/m3. The cardboard has a mass of 0.10 kg and the jet has a diameter of 10 mm.
2. A gas enters a 2 m diameter cylindrical pressurized tank with an existing pressure of 4 atm at a speed of 60 m/s and a density of 8 kg/m³ through a 55 mm diameter pipe and flows out from the tank through a pipe with an area of 30 mm?. At a certain instant, the pressurized gas flowing out has a speed of 80 m/s and a density of 12 kg/m³. Determine the amount of gas in the tank when density in the tank is decreasing at a rate of 1 kg/m³/s. The temperature in the tank is 20 °C.
A roofer tosses a small tool to the ground. What minimum magnitude vo of horizontal velocity is required to just miss the roof corner B? Also determine the distance d. Answers: Vo = d = i -2.7 m 10 B 1.4 m + 0.9 m +6+4 m 3.3 m m/s
6. A small particle is placed inside the frictionless, semicircular tube of radius R shown in the figure below and released. Using angular momentum methods, show that the particle's equation of motion is given by Ö + (g/R) sin(0) = 0. Hint: Start with dHo/dt = EM₁ e
i need the answer quickly
While travelling on a dirt road, the bottom of a car hits a sharp rock and a small hole develops at the bottom of its gas tank. If the height of the petrol in the tank is h=h= 31 cmcm, determine the initial velocity of the petrol at the hole. Given that there are no minor or major losses and density of petrol is ρ=ρ= 778 kg/m3
Explain the physical meaning of each of the terms in Equation 3. The momentum equations for a rotating shallow homogeneous fluid with a free upper surface (i.e. the shallow water equations) are equation 1 & 2. where u(x, y,t), v(x, y,t) are the velocities on the free surface, and h(x, y,t) is the depthof the free surface.