A 13-kN hydraulic press for removing and reinstalling bearings in small-to medium-sized electric motors is to consist a commercially available cylinder mounted vertically in a C- frame, with dimensions as sketched in the Figure shown below. It is being proposed to use ASTM A-48 (Class 50) gray cast iron (brittle material with ultimate strength, S 345 MPa) for the C-frame material. Calculate the bending moment about the centroidal axis upto 3 digits after decimal point in KN.m? 18 mm 38 mm 13 kN 25 mm 10 mm -90 mm A 10 mm

Q: Calculate the minor axis (z-z) axial flexural buckling capacity of a 152×152×30UC S275 assuming an…

A: Whenever underlying individuals are exposed to compressive powers , the individuals might fall…

Q: A solid cantilevered aluminum alloy rod, 10-mm in diameter, supports a Parol (Christmas Lantern).…

A: The bending moment is M=10.2 Nm. The diameter of the rod is d=10 mm. The yield strength of the…

Q: mechanical design A steel cantilever is 200 mm long is made from AISI 4340 quenched and tempered at…

A: after using scientific calculator The diameter d of the cantilever is approximately 5.2 mm

Q: A 'L' shaped post with a cylindrical cross-section is loaded with a concentrated load at its free…

A: Given: To find: State of stress at P1

Q: Explain Torsional Moment with example?

A: The torsional moment, also known as twisting moment, is a couple that acts in a plane parallel to…

Q: Pravinbhai

A: The objective of the question is to calculate the deflection at pulley B and point C of a steel…

Q: Problem 1: In the figure below a solid bar with a 1.00 in diameter is subjected to a bending moment…

A: Given data, Diameter of the solid bar, d = 1 in Twisting moment and bending moment are equal, i.e.,…

Q: Compute the design factor in the middle portion only of the rod AC if the steady vertical force on…

A:

Q: Euler's critical buckling load

A: Given; Case of slender column of length l, and        flexural rigidity EI built-in at its base

Q: The A frame shown in the figure is attached to an overhead beam by 2 cap screws, each of which can…

A: To determine the appropriate screw for the given load and conditions, we need to follow several…

Q: 35 mm 10 kN-m 2.36 x10° mm G, 50 GPa (1) C2 40 mm (2) 4.02 x10° mm A G2 = 25 GPa 2400 mm 3100 mm A…

A:

Q: Q2: Figure (2) shows a rotating shaft, simply supported at bearings atA and B. The shaft is loaded…

A:

Q: The solid 37 mm diameter steel [E - 200 GPa] shaft supports two belt pulleys. Assume that the…

A: Area of moment of inertia is property of object shape which help in finding the deflection of beam…

Q: i) Absolute maximum shear stress in AB Ans (TAB)mar 28.64 GPa 400 mm ii) Absolute maximum shear…

A:

Q: For same problem setup in Q1 except for the length, if the yield strength is 145 MPa,  calculate the…

A: For solution refer below images.

Torsion

In mechanical engineering, torque, torsion, and twisting moment are three of the most important concepts which have different meanings. Torque is the consequence of a moment of a force that produces an angular acceleration in a body or induces rotational kinetic energy in a body. For instance, in an automobile, the power transmission shaft is a body that is always under rotation due to the external torque acting on it, this torque is created by the engine.