A 120-lb cabinet is mounted on casters that can be locked to prevent their rotation. The coefficient of static friction between the floor and each caster is 0.30. Assuming that the casters at both A and B are locked, P C B 24 in. Determine the largest allowable value of h if the cabinet is not to tip over. Answer in 3 decimals inch

Q: Which type of hardness can be removed by Reverse Osmosis method (RO)

A: The water hardness is of two types, they are permanent hardness and temporary hardness. The…

Q: When mixing with water, the calcium silicates react with water molecules to form -----and Calcium…

A:

Q: A rubber ball is inflated to a pressure of 65 kPa. At that pressure, the diameter of the ball is 240…

A:

Q: An acetal polymer block is fixed to the rigid plates at its top and bottom surfaces. If the top…

A: Calculate the shear stress and shear strain. Then using Hookes law the value of shear modulus can be…

Q: Two silicon wafer sizes are to be compared: a 6.0-in wafer with a processable area = 5.85-in…

A: case 1- Wafer size 1 = 6.0 in processable area 1 = 5.85 in case 2- Wafer size 2 = 12.0- in…

Q: 5. Determine if the flexural stress of the chocolate will increase or decrease if changes are made…

A:

Q: Show full solution

A:

Q: Find the optimum binder content for the results of Marshall test bellow and determine the properties…

A: Approach to solving the question: To find the optimum binder content and the properties of the…

Q: I need the answer as soon as possible

A: Given data:- Cross-section of plate is 0.5 m × 0.3 m  Thickness of plate is 0.01 m Young's Modulus…

Q: I am still confused with the sign convention we were told that in rock mechanic the sigma y in…

A: This question is related to the Stresses transformation from Strength of the material from Civil…

Q: Taking 'k' components 0. 77TEC + 0. 8TBD=1440. -(1) Taking 'j' components 0. 514TEC – 1.6TBD=0.….…

A:

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.