A 12 V generator has an internal resistance of 0.05 ohm. Two loads are connected in parallel to its terminals, one drawing a 12 A current and the other dissipating energy at the rate of 200 W. What is the terminal voltage of the generator with this load? Ans. 0.82 volts

A 12 V generator has an internal resistance of 0.05 ohm. Two loads are connected in parallel to its terminals, one drawing a 12 A current and the other dissipating energy at the rate of 200 W. What is the terminal voltage of the generator with this load? Ans. 0.82 volts

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: To change the direction of rotation of a series wound DC generator the general rule is to

A: To change the direction of rotation of a series wound DC generator Note: we always change the…

Q: What is difference in alternator and generator?

A: Difference between alternator and generator

Q: Determine the peak-to-peak ripple and dc output voltages in Figure 2. The transformer has a 48 V rms…

A: Step 1:Step 2: Step 3: Step 4:

Q: A 6-pole lap wound generator has 900 conductors. The e.mf induced per one tur being 3 V. the…

A: Given lap connected , So, No. of poles = No. of parallel paths = 6 Given voltage per turn = 3 volts…

Q: A long shunt d.c. compound generator delivers 110 kW at 220 V. If r = 0.01 ohm, r = 0.002 ohm, and…

A: We have been given an long shunt dc compound generator as shown in figure. Given data, Voltage (V)…

Q: v. With reference to an 50 Hz3 phase alternator explain how P,Q,V and F are controlled.

A: It is asked to explain the control of P (active power),Q (reactive power), V (voltage) and F…

Q: If it is desired to bring alternating current out of a generator, what kind of a "take-off" system…

A: If the alternating current is required from the generator a copper or brass rings are connected at…

Q: An alternating f.e.m generator has an effective value of 2000 V and a frequency of f=100 Hz. Find…

A: An alternator f.e.m generator has,The effective voltage of the generator, .The frequency of the…

Q: The shunt DC generator gives almost O Constant current O None of these O Constant voltage O Constant…

Question

A 12 V generator has an internal resistance of 0.05 ohm. Two loads are
connected in parallel to its terminals, one drawing a 12 A current and the other
dissipating energy at the rate of 200 W. What is the terminal voltage of the
generator with this load? Ans. 0.82 volts

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

10. A potential difference of 250 V is applied to a field winding at 15-C and the current is 5 A. What will be the temperature of the winding when current has fallen to 3.91 A applied voltage being constant. Assume temperature coefficient at 15'C is equal to 1/254.5 per °C
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
Ip Ep=40 V f = 60 Hz N₂= 20- N₁ = 120 Find the maximum flux om om = Find the magnitude of the induced secondary voltage Es Es = units + Is Es units If the coefficient of coupling (k)= 0.75, determine the magnitude of the induced secondary voltage Es Esk=0.75 = units
Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
What conditions must be met before two alternators can be paralleled together?
An ac resistance is higher than a dc resistance. True False
The emf induced in the dc generator armature winding is * O AC and DC O DC O None of the above O AC
A three-winding transformer is connected to an AC voltage source as shown in the figure. The number of turns is as follows: N₁ = 100, N₂ = 50, N3 = 50. If the magnetizing current is neglected, and the currents in two windings on secondary side are 2230° and 22150°, then what is the value of the primary current in Ampere? I 0000000000- N₁ № ₂ Z 00000 00000 Z N3 H I₁₂ I₁₂₁ ¹3
I need the answer quickly please
2- a. b. c.