A 10-kg mass of superheated refrigerant-134a at 1.2 MPa and 70°C is cooled at constant pressure until it exists as a compressed liquid at 20°C. (a) Show the process on a T-v diagram with respect to saturation lines. (b) Determine the change in volume. (c) Find the change in total internal energy.

Q: Consider the thermal system shown below. The temperature of the inflow liquid is kept constant, and…

A: Thermal system The term "thermal system" refers to a system that stores and transfers heat. A…

Q: Problem 2 Refrigerant-134a enters the compressor of a refrigeration system as saturated vapor at…

A:

Q: A glass flask whose volume is 1000.00 cm³ at 0.0°C is completely filled with mercury at this…

A: Step 1: Find the total volume expansion of mercury when the temperature increases. We know the flask…

Q: Prob-3 A cyclic machine, shown in Fig. below receives 300 kJ from a 1000 K energy reservoir. It…

A: The high temperature of the energy reservoir TH=1000 KThe low temperature reservoir, TL=400 KEnergy…

Q: 2-64 Nitrogen enters a steady-flow heat exchanger at 150 kPa, 10°C, and 100 m/s, and it receives…

A:

Q: Please solve both for my homework.

A: Step 1: Step 2:Determining Work Input for Adiabatic PumpWe'll solve for the work input (W) required…

Q: ntly), but with 10 kg of air at 800 kPa, heated at constante pressure up to 400°C. Use the values…

A:

Q: 2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank…

A: Given data:- Initial pressure =30×105 Pa Operating temperature =200°K Volume of tank =40 m3 Length…

Q: 2. Domestic "tap" water generally has a conductivity in the range 0.5 - 1.0 ms/cm. Based on your…

A: The total amount of dissoloved salt in water can be easily estimated by measuring the specific…

Q: A piston-cylinder assembly contains ammonia, initially at a temperature of -20°C and a quality of…

A: To solve this problem, we can use the first law of thermodynamics, which states:ΔU=Q−W Where:ΔU is…

Q: A heat engine with 0.305 mol of a monatomic gas undergoes the cyclic procedure shown in the pV…

A: Using the given data, we can calculate the temperature at stage 1 (T1) and stage 3 (T3), and then…

Q: Refrigerant-134a is throttled from the saturated liquid state at 850 kPa to a pressure of 200 kPa.…

A:

Q: 1. Oil that has a density of 880 kg/m flows under a head of 30 m. The pipe that the oil flows…

A: We have to determine the flow in dm3/sec as per the given data in the question and we have to also…

Q: Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 250 lb/in²…

A: To solve this problem, we can use the ideal gas law and the definition of work for a…

Finite Elements for Heat Transfer Problems

Finite element analysis (FEA) is a simulating process of the manner and assembly of an object under obtained conditions. It is used for assessing the finite element method (FEM) which includes one or more solution algorithms. General problem areas of interest are structures, heat transfer, the flow of fluid, transport, and some boundary value problems.