A 100/S00 V. 1 KVA, 50 Hz transformer was put through open and short-circuit tests to find its internal parameters. The test conditions and derived parameters are as follows Open circut test: The high voltage side terminals were open. The low voltäge side was connected to 10020ª, 50 Hz supply. The low voltage side current was measured as 50245º MA. Short-circuit test The high voltage side terminals were short-circuited. The low voltage side was connected to a variable voltage supply (50 Hz). A full load current of 102-30° A was achieved when the variable voltage supply was at 820° V. The transformer was then put to operation by connecting a load of 400230° 2 to the high voltage side (secondary) while applying a primary voltage of 10020° V. Calculate the primary current (the current drawn from the power supply).

A 100/S00 V. 1 KVA, 50 Hz transformer was put through open and short-circuit tests to find its internal parameters. The test conditions and derived parameters are as follows Open circut test: The high voltage side terminals were open. The low voltäge side was connected to 10020ª, 50 Hz supply. The low voltage side current was measured as 50245º MA. Short-circuit test The high voltage side terminals were short-circuited. The low voltage side was connected to a variable voltage supply (50 Hz). A full load current of 102-30° A was achieved when the variable voltage supply was at 820° V. The transformer was then put to operation by connecting a load of 400230° 2 to the high voltage side (secondary) while applying a primary voltage of 10020° V. Calculate the primary current (the current drawn from the power supply).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When secondary is fully loaded, transformer regulation is less than 1 percent. It shows that it is a good transformer. T or F
Draw a block diagram of a power supply from transformer up to regulator with corresponding waveform.
don't copy
Please ? help o have no knowledge in this field With explanations Part c, d and e please only please
The rated power of a certain transformer is 1 kVA. The transformer operates at 60 Hz and 120 V ac. at 60 Hz and 120 V ac. The secondary voltage is 600 V. (a) What is the maximum current at the load? (b) What is the smallest RL value that can be excited? (c) What is the largest capacitor that can be connected as a load?
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10.The output voltage of the rectifier is 400 V DC. The rating of source side of three phasedelta – star transformer is
The open-circuit voltage of 240 V and the full load secondary voltage of 226 V, then the % regulation of a transformer is
02. A certain transformer operating at a particular frequency has equal hysteresis and eddy current losses. If the voltage and frequency are doubled, the ratio of the hysteresis and eddy current losses is (a) 1:1 (c) 2:1 (b) 1 : 2 (d) 1:4
Under short circuit test, the short circuit voltage of transformer is O a. Equal to the rated voltage ОБ. O b. (3-5) % V rated O c. Maximum O d. Zero