A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of compensating winding turns per pole is .approximately equal to ----- if the ratio of pole arc/pole pitch is 0.72

Q: fca) = Th 2. 2.

A: See attachment

Q: Q4/choose the correct answer: .playing football Yesterday I . o library for study. O Is Go O Was…

A:

Q: Q-01 (What is called Buck Converter & What is called Boost Converter?)  give two examples for each.

A: Explanation: The buck converter is a ubiquitous DC-DC converter that correctly converts an excessive…

Q: Prove

A:

Q: Electronic What is Polymorphism. What is Mailbox.

A: The System Verilog provide dynamic array construct. In packed array one location and whole location…

Q: What is the Possibility of Incorrect Decisions?

A: Probabilities of correct and incorrect decisions can be seen in given graph. Here we can see that it…

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

A:

Q: Which of the following statement/s defines a control system?(select 3) control systems can move…

A:

Q: A supermarket has a one entrance-door and one exit-door. The customer capacity of the supermarket is…

A: According to the question, we need to write the FBD program.

Q: An amplifier has an input of 0.2W. it has an internal gain of -500 with a 10% distortion. If…

A:

Q: paper sponding percentage share in the marks are 30, 25, 25 pt all the questions and the student is…

A:

Q: Find VDc if VAN = VBN = VCN= 120 volts... Half-wave Three-phase Rectifier Conduction Waveform…

A:

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: 6 Choose the correct form. 1 I went to the shops for to buy / for buy / to buy some shoes. 2 Do you…

A: We are authorized to answer three subparts at at a time since you have not mentioned which part you…

Q: How are the input and output parameter options for a function block set? Multiple Choice O O Pin is…

A: How are the input and output parameter options for a block set?

Q: Type N connectors are used in moisture environments and used with consumer audiovisual electronics…

A: True.

Q: • Sensors on 3 landing gear • The pilot has a Gear Down Control switch • When the Gear Down Control…

A: The required logic design can be obtained by using the truth table derived based on the given…

Q: 1- Is the Gray code arithmetic code? Why? Where this code used?

A:

Q: Q) In measurement system, which of 1 point the following static characteristics are desirable? *…

A: Accuracy is the degree of closeness of the measurement and sensitivity is the how output is reacts…

Q: A person is recording measurements from an analog data reader. During the first reading, he was not…

A: Since we are allowed to solve only up to first three parts of a question the below answer contains…

Q: A 50:1 potential transformer is connected to a 150-volt voltmeter for the measurement of the…

A: It is given that: Transformer ratio(k)=50:1 Voltmeter=0-150 volt meter reading=133

Q: Question 4b The school board is trying to evaluate a new math program introduced to second-graders…

A: The  above chart tells us that all the points which are between the upper and the lower control…

Q: A B a-Horse riding. b-They're a bit strict. C-OK, but boring near the end. What's the weather like?…

A: In this question, some sentences given...We have to match them with true answer...

Q: Explain the conditions and operation of Synchronous machine parallel operation with diagram

A: Operation of synchronous machine

Q: All forms of communication have a(n)_ built into them. O A. bias O B. Mercator projection

A: Communication System- The communication system model is described as a communication exchange…

Q: Construct a truth table to design an automated watering system controlled by soil moisture, rain…

A: To design the truth table for the automated watering system controlled by three inputs: soil…

Q: For specific system the root locus is plotted as shown in Figure (1). Are first method (or/and)…

A: The Ziegler-Nichols Act is a PID tuning law that seeks to generate positive values ​​in three PID…

Q: Which of the following statement/s defines a control system?(select 3) control systems can move…

A:

Q: QUESTION 9 Which of the followings is true? The capital letter V' has been typically deployed to…

A: Question 9: Answer is B  because in electromagnetic theory we represent Volume by " V " and…

Q: I have an O Gauge track and would like to convert it into a “sensored” track. Additionally, I would…

A: According to the question, an O-gauge track and would like to convert it into a “sensored” track.…

Q: Match the appropriate number with the given statements. 4 DIGITAL (PWM-) OO UNO TX ON ARDUINO RX…

A: Given,

Q: ANSWER FAST PLEASE, Show Step By Step, NO AI or chat GPT

A: we need to match given property and phrase.

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.