A 10 kW, 250 V Shunt motor has an armature resistance of 0.5 ohm and a field resistance of 200 ohm. At no load and rated voltage, the speed is 1200 rpm and the armature current is 3 A. At full load and rated voltage, the line current is 47 A and because of armature reaction, the flux is 4 % less than it no load value. a.) What is the full load speed? b.) What is the developed torque at full load?

Q: The 3-phase wound-rotor induction motor has .... . a) high starting torque b) low starting current…

A: In this question , we will write induction motor starting related questions..

Q: A compound generator has a lap-wound armature with 200 slots and four turns per coil. It is rotating…

A: As per the guidelines given, We can only provide the solution of the first three questions in…

Q: An 8 pole DC shunt generator with 900 wave-connected armature conductors supplies 10ohm  at 500 V…

A: To find the answers, we can use the following formulas and calculations:1.1 The flux per pole:The…

Q: A 230V DC series motor operates at its full load current and speed of 22A and 750 revolutions per…

A: Types of DC Motor Seperetely excited motor Series Motor Shunt Motor Compound Motor Differential…

Q: A 250V series motor runs at 500 rpm at rated load current of 75 A. The armature circuit has a…

A: It is given that: V=250 VN1=500 rpmIL1=Ia1=75 ARa+Rse=0.2 Ωϕ α Ia

Q: A series DC motor has a series-field winding of 25 turns per pole. Its armature resistance is 0.15…

A:

Q: A shunt DC motor is supplied by 520V terminals voltage and is used to supply a mechanical load with…

A: The solution can be achieved as follows.

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.