8 rapid sand filters are used to treat 35 MLD of water with rate of filtration4000 lit/hr/m². If back washing rate is 4 times rate of filtration and duration of backwash is 15 minutes operated once in every 24 hrs, then the percentage of filtered waterrequired to back wash the filter is

given- 8 rapid sand filters, 35 MLD water, filtration rate=4000 lit/hr/m2,back wash time=15 min,

8 rapid sand filters are used to treat 35 MLD of water with rate of filtration 4000 lit/hr/m². If back washing rate is 4 times rate of filtration and duration of bac wash is 15 minutes operated once in every 24 hrs, then the percentage of filtered wa required to back wash the filter is

8 rapid sand filters are used to treat 35 MLD of water with rate of filtration 4000 lit/hr/m². If back washing rate is 4 times rate of filtration and duration of bac wash is 15 minutes operated once in every 24 hrs, then the percentage of filtered wa required to back wash the filter is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What is the solids loading on the filter assuming an influent TSS = 20 mg/L?

A: Step 1: Step 2: Step 3: Step 4:

Q: A rapid sand filter is designed to treat (18000 m³/day) of rate of (1.8 l/m².sec). The filter…

A: Give Data A rapid sand filter is designed to treat (18000 m³/day) of rate of (1.8 l/m².sec). The…

Q: Name:.. 11. An activated sludge system has a single aeration basin with a volume of 300,000 gal and…

Q: Solve,

A: Given: Effluent BOD concentration=80 ppm=80 mg/L Volume of filter, V=825 m3 Discharge, Q=50 L/sec…

Q: An activated sludge treatment system to treat a wastewater flow rate of 0.3 m/s of primary effluent.…

Q: QUESTION FIVE Calculate the efficient substrate concentration, the thickening ratio and the purge…

A: Since Xi=0, we assume the effective thickening ratio is not applicable as the system does not…

Q: 10-9. A dual-media filter contains anthracite with an effective size of 1.2 mm and uniformity…

Q: Q #2 Design A rapid sand filter to serve a little city with an annual water consumption rate of…

Q: Consider a pilot scale sand filter with the following characteristics. Diameter of cylindrical…

Q: e fast answer

A: Solution is determined as follows

Q: In a BOD test 1.0 ml of raw sewage was diluted ml and oxygen to 100 the dissolved concentration of…

A: Given data in question 1 ml raw sewage Diluted with 100 ml Dissolved oxygen 6 ppm and 4 ppm…

Q: 01: Find the area of rapid sand filters and find the dimensions (if fivé units are used), for the…

Q: 3) Suspended solids Small particles of organic or inorganic materials that settle down in,…

A: ASKED: To check the given statement if it is true or false. Given statement: Suspended solids…

Q: A rapid sand filter is to be provided in a water treatment plant, to process 60 MLD of water for a…

Q: In a BOD test 1.0 ml of raw sewage was diluted to 100 ml oxygen and the of diluted dissolved sample…

Q: Q19: the secondary treatment is achieved by : Select one: a. rotating biological contactors and…

Q: 4.2. The aspiration of air sampling was performed though the absorbing mass (volume 10 ml) in the…

A: Data given Total volume of absorbing mass = 10 ml Absorbing solution used for analysis = 3 ml…

Q: 4. Wastewater sample was prepared and incubated at 20°C for 5 days for BOD analysis. Sample volume…

Q: A rapid sand filter system is designed for a city with population is 800,000 and the average water…

Q: During filtration cycle, the valves A, B, C and E open/close as follo 1) A and B open and C and E…

Q: in a BOD test, 1.0 ml of raw sewage was diluted to 100 ml and the dissolved oxygen concentration of…

Q: The sewage flow and recirculated flow of a trickling filter is 4 MLD and 6 MLD, then recirculation…

A: Sewage flow of trickling filter(I)=4MLDRecirculation flow(O) = 6 MLDTo Determine:Recirculation…

Q: The following diagram illustrates the operation of a rapid sand filter. Washwater storage tank Water…

A: From the figure it can be seen that valve D is on the line taking water after filtration and also…

Q: A filter press with an effective filtering area between 350m^2 operates constantly maintaining a…

A: The objective of the question is to calculate the filtration velocity at a given time (t=120m) for a…

Q: What is the rapid sand filter surface area required for filtering of 10 MLD water assuming a…

A: water to be filtered Q=10 MLD Filtration rate FR = 100,000 l/m2/day Surface area=?

Q: A complete mix activated sludge secondary treatment plant is wasting from the return sludge line.…

A: Solution: Given Data: Mean cell solids residence time Qc=5 daysV=1000 L=1 m3MLVSS Xt=2000 mg/LWaste…

Q: In a BOD test 1.0 ml of raw sewage was diluted to 100 ml and dissolved oxygen the of diluted…

Q: Sketch a preliminary process flow diagram for a split-treatment lime-soda ash water treatment plant…

A: The sketch of the treatment plant is as follows.

Q: Determine the diameter of a trickling filter for a wastewater flowing at the rate of (13500/100)…

A: Wastewater flowing at the rate of (Q = 13500/100) gallons per minute. Concentration for the…

Q: - A 25 ml water sample is placed in a dish that wt. 50g, after evaporation and drying at 103°C, and…

Q: 23-A) An activated sludge system is to be used for treatineat of 10000 m'day of municipal…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Design a trickling filter system for BOD removal without the nitrification requirement, to treat…

A: Given,Average flow of waste water=200 m3/dInfluent BOD = 200 mg/LInfluent Ammonia = 42…

Q: By means of equations and illustrations, explain clearly the difference between constant rate…

A: Constant rate filtration - The resistance offered to the flow is constant or approximately more or…

Q: A rapid gravity filter operating with an influent concentration C0 of 20 mg/l suspended solids has…

Q: A conventional trickling filter is to reduce BOD of wastewater from 250 mg/1 to 100 mg/1. The…

Q: ) Calculate the organic loading rate of the trickling filter in lb BOD/day/1000 ft3 with the data…

A: INTRODUCTION; Trickling filter is designed to remove waste material from the waste water sample. It…

Q: determine the air flow rate , residence time, gravitational separation oval efficiency when the…

Q: Calculate the anthracite diameter for a deep-bed anthracite filter of 1.5m with a porosity of 42%.…

A: Given: The depth is 1.5 m. The porosity is 42%. The headloss is 1.8 ft. The filtration rate is 13.5…

Q: * .A - list of sources duration comprehensive O successive

A: INTRODUCTION: in this filling the gap , the word that depict the nearby answer is selected.…

Q: er of transfer units, and the height of the p ng/L and this must be reduced to 75 µg/L

A: Solution- Lequid loading rate Mass rate Mass rate = 1kg/L×350 gal/min =…

Q: A filter is designed with the following specifications. The anthracite and sand have densities of…

A: A filter is designed with the following specifications. The anthracite and sand have densities of…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

8 rapid sand filters are used to treat 35 MLD of water with rate of filtration
4000 lit/hr/m². If back washing rate is 4 times rate of filtration and duration of back
wash is 15 minutes operated once in every 24 hrs, then the percentage of filtered water
required to back wash the filter is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q. Discuss the following sentences: 4- In CRP, the rate of evaporation is independent of moisture content. 5- Effective sintering technique is obtained using spark plasma sintering.
Q-24. Civil Engineering problem.
A continuous stirred tank reactor (CSTR) Activated Sludge Process is used to treat municipal wastewater after primary sedimentation. The following data is available: Primary Effluent Flow Rate (Q) Primary Effluent BOD Concentration (So) Secondary Effluent Biomass Concentration (Xe) Mixed Liquor Biomass Concentration (X) Solids Retention Time (SRT) Waste Sludge Flow Rate (Qw) Value 450 200 O 0 3,000 5 8 Biomass Concentration in RAS (XR) 8,000 O 250 million gallons, 0.28 gBOD/gVSS.d, 13.3 hours 107 million gallons, 0.28 gBOD/gVSS.d, 5.7 hours O 107 million gallons, 0.42 gBOD/gVSS.d, 5.7 hours 107 million gallons, 0.28 gBOD/gVSS.d, 12.2 hour Unit mgd mg/l mg/1 mg/l days mgd The bioreactor volume (V), F/M ratio, and HRT are respectively: mg/l
A rapid sand filter is to be provided in a water treatment plant, to process 60 MLD of water for a town. There is a provision of allowing 3% of the filtered water for storage to meet the backwashing requirement. Rate of filtration for the filter system is 20 m3/m2/hr. Each day 20 min of backwashing is done. Then, A Flow of water during filtration is laminar flow and flow of water in case of backwashing is turbulent. B The area of filter unit is 128.75 m2 C The area of filter unit is 130.55 m2 Correct Option Rapid sand filter is less efficient in removing bacteria. Correct Option
A single media filter has a 720mm deep bed of sand (diameter = 5 x 10^-4 m, shape factor = 0.8). The porosity of the system is 0.40. The filtration rate is 1.2 (L/s)m^2. The water viscosity is 1.14 x 10^-6 m^2/s. A. What is the Reynold’s number of the filter B. What is the friction factor for the filter? C. What is the total clean head loss across the filter in m?
2,13. Determine the suspcnded solids and the percent volatule matter in a sohds sample based on the following data: Sample size - 25 mL. Tare mass of filter 1.5325g Tare mass of filter plus retained solids-1.5415 g. Tare mass of filter plus retained ash-1.5378g
If (Qr/Q=120 percent of discharge), effluent BOD concentration=80ppm, volume of filter =825m3 , discharge =50L/sec , The influent BOD concentration equal: Choose one: a. 277.89 b. 277.2 c. 276 d. 275
Be fast / quick.pls.
I need a step by step process on solving this homework question.
This is also known as the groundwater zone. Select the correct response: Capillary Fringe Soil water zone Saturated zone Aeration zone
Q2. A settling tank sludge sample is tested for solids. The sample and the dish weight (74.69) g, the dish weight (21.2) g. after drying, the dish with dry solids weight (22.3) g. what is the percent of total solids (%TS) in the water sample?