8) A 740 N person stands on the high end of a ramp that's tilted up at 35° from due East, 3.1 m along the ramp from the ground-level end of the ramp (the pivot). For r being the displacement from the ground level end of the ramp to where the person is standing and F being their weight, find the torque t=r x F. Make sure the direction of your answer is properly defined.

Q: piece of metal subjected to three forces is fold as shown in the figure. Replace the three forces…

A:

Q: Draw the Free-body diagram in the image below of POINT A, and  accurately label everything.…

A:

Q: The picture attached shows a boom that supports the weight 2000 N. The boom is supported by the…

A:

Q: 3-4 3-2) Find the TRUE magnitude and direction of the RESULTANT FORCE and MOMENT AT POINT A TTTTT…

A: To find resultant and moment diagram

Q: 2. Determine the scalar component of the moment of the 750-N force shown in Figure 2 about the axis…

A:

Q: Figure F₂ 500 lb = F₁ = 375 lb PA 8 ft- 6 ft- 5 ft- B 0.5 ft 30° 1 of 1 F3160 lb Part A Determine…

A:

Q: Find the magnitude of the net torque on the wheel in Figure below about the axle through O, taking a…

A:

Q: 8 kN 2) Find the torque created by the 2 forces about the origin. Ignore the 15 kNm load. (It is…

A:

Q: The total torque of the forces on the ruler around a axis perpendicular to the ruler and passing…

A:

Q: A square plate with sides 1.5 m in length can rotate around an axle passing through its center of…

A: Given Data Force acting at top left edge is: F1=30 N Force acting at the bottom left edge is: F2=20…

Q: Add the following forces to find the resultant force. V1 = 150 g @ 470 V2 = 550 @ 324° V3 = 350 g @…

A:

Q: 1) Find the +Y -120lb 60 180lb + 70lb 30° 150lb +Y FORCE e F =F.Cos(e)F,=F.Sin( e) (Ib) R = %3D

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: A clutch was balanced by having four masses placed on the clutch cover at the same radius. Three of…

A:

Q: Fill the table with the correct data and signs (+) (-) please.

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.