6:03 PM PO O+ " 7792 Expert Help EtZORY#3118 13:40 The circuit model for a single phase. Syachronous machine is given as Z FR₂+ixt 0 口 V<0 Show that the the Phase Power P The circuit model for a single Phase Synchronous machine is given as Z5 Rst ixt 0 Show that the that Phase Power P is given by P = 3 12611 vs sin 8 Ixs +1 ticket

6:03 PM PO O+ " 7792 Expert Help EtZORY#3118 13:40 The circuit model for a single phase. Syachronous machine is given as Z FR₂+ixt 0 口 V<0 Show that the the Phase Power P The circuit model for a single Phase Synchronous machine is given as Z5 Rst ixt 0 Show that the that Phase Power P is given by P = 3 12611 vs sin 8 Ixs +1 ticket

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.3MCQ: The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of...

See similar textbooks

Similar questions

A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
The direct electrical connection of the windings allows transient over voltages to pass through the auto transfonner more easily, and that is an important disadvantage of the autotransformer. (a) True (b) False
Q9. What is the basic principle that a cage winding can be represented by a three-phase winding? Give your explanation.
An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each containing 5 conductors. The winding is distributed and full pitch. All the conductors of each phase are in series and flux per pole is 30 mWb which is sinusoidal distributed.Calculate the number of pole.
Sketch a single-phase voltage sag event and explain its characteristics. List three potential causes of voltage sags.
The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10 ohm. The duty cycle is 0.4 the voltage drop across the switch may be taken as zero, Calculate : (a) Average and RMS value of output voltage. (b) Average and RMS value of output current.
c dep15m Problem 2 A ferromagnetic core with a relative permeability of 2000 is shown in Figure. The dimensions are as shown in the - 30 cm 30 cm 7 cm diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is the flux in each of the left, center, and right legs of the core? What is the flux density in each air gap? 30 cm 0.05 cm 300 turns 0.07 cm 7 cm
1-Adiust the function generator to give (10 v p.p )(170) Hz.
A dc series generator is sipplying a current of 10A to a load trhrough a feeder of total resistance 1.5 ohms. The generated voltage is 550V. The armature and series field resistance are respectively 0.5 and 0.6 ohm respectively. Determine the voltage at the terminal of the generator and at the feeder.
A 6 pole wave wound d.c. shunt generator has 500 conductors. A generator delivers 50 kW of power at 250 voltage at full load. The resistance of the field circuit is 125 2. Actual brush shift is 10°. Then find the demagnetizing and cross magnetizing ampere turns per pole and how many additional turns must be wound on each pole to eliminate the demagnetizing effect.
A three phase stator is shown below. The positive polarity of the currents is shown in the image. The windings are fed with the following balanced three phase currents: la-lmcos(wt) Ib-Imcos(wt-90°) Ic=Imcos(wt+90°) a) Where would you label the positive axes of all three phase windings in the image? b) Draw the magnetic field vectors produced by each single phase, and the total rotating magnetic field for wt = 0° and wt = 90° in the following figures. c) Is the rotating magnetic field clockwise or counter-clockwise?